Network Management

hiI have a 4431 with IOS 15.4(3)S6a which works well.A cisco engineer advises me to upgrade in 16.5.5 so I did it... but router crashed. In checking crash file, it seems to be one of my EEM script that crashes router after the reload command, see bel...

Hello all,I am trying to connect to the console port of my cisco vpn concentrator 3000. My putty configuration is what the cisco technical doc suggests. I have a female rs232 to usb to use one of the virtual COM ports on my laptop, however I am not h...

HelloI'm writing regarding an issue of high CPU utilization that I have on a Cisco Router 2911. It appears when any traffic longer than few seconds is started. I have gone through many documentations and forums and for now I haven't found the right s...

Hello,   if i want  to configure  the serial  interface  between  a  cisco 4331  AND  cisco 2921 ..  is it possible ??  or  to configure this option just can be done between routers  of the sam family  ( 4331 ) . 

I have a Cisco SG350-28 switch I have configured,  It's the 2nd switch in line of my route switch. I used to have connectivity to it until a 3rd party installed a new piece of equipment on my VLAN.I can ping the switch (10.2.3.3) through my firewall ...

I'm looking to use a cli script in Prime to reboot a certain group of APs late at night. I've tried:#INTERACTIVEconfig ap reset AP01 <IQ>y/n<R>yconfig ap reset AP02 <IQ>y/n<R>y...#ENDS_INTERACTIVE Which works fine for the first few on the list, but e...

Hello Guys, Can anyone help me here? I am trying to set ip routes between 6 districts and I am able to ping between 2 districts "Corozal and Orange Walk" and vice versa. I am a bit confused when trying to configure the ip route from Corozal to Belize...

Hello all. I work in a Public sector. Now here i am facing an issue for quite a long time. There are three Vlans(201,50,32). On Vlan 32 there is a reports portal server which is used to update the daily reports. When i access the reports server from ...

Hi ! Does the ASA5500-X (Software Version 9.7(1)21) support pooling any OID to track IP LSA information via SNMP? for example, which is oid for sla monitor 10 Latest operation return code?:sla monitor 10type echo protocol ipIcmpEcho 192.168.16.X inte...

hii got switch sg250-08 and i need to make port mirror.frimware 2.4.5.71 i dont find the feature on the menu, is it possible to do? thanks for your help.  

I am having trouble setting my cisco switch sg350 to layer 3 mode as I cannot find the buttons shown in the image below. 

Hello,how can I read SLA RTT values via SNMP?I have IP SLA udp-jitter configuration and I would like to graph RTT vaules:Number Of RTT: 10 RTT Min/Avg/Max: 789/798/809 microseconds I did snmpwalk but cannot find relevant OIDs.Platform is Nexus7700

Hey guys,i just got an Cisco AIR-CAP1602I-E-K9 from my work and connected it to my router with DHCP turned on.It shows up there with the IP 192.168.0.248 and i can ping it. But if i try to open it on the browser, nothing happens. Is it may a general ...