Network Management

Hi all,   So i have an EEM script that downloads a config file and save it straight to nvram:startup-config. e.g action 1.0 cli command "copy ftp://192.168.0.128/config.txt nvram:startup-config I also in the same script download a the firmware for th...

Hi, I have a new router 4331 but am unable to ping the device. What could be the problem.   I have upgraded the IOS to Everest 16.06.02   Thank you in advance

Hi All,   I'm looking for the out-of-band console  server for Cisco devices  which I can use when the network is down. What kind of OOB  console server are you guys using?   Thanks, Anton  

Running PI 3.2 Hyper-V 2 Issues 1. Wrong CLI Credentials 2.  Partial Collection Failure When conducting device discovery on Cisco ISR-4000 ISR's (IOS-XE16.2) Prime can poll and see the devices as well as the inventory of modules inside of the ISR's b...

All,   I have a pair of 3750 L3 switches which we use as our internet edge switches running the below code: sho verCisco IOS Software, C3750 Software (C3750-IPSERVICESK9-M), Version 15.0(2)SE7, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisc...

Following user guide, deleted all scope, added new scope, and reloaded DHCP server, but lease list is empty. Looks like old scope still occupy lease.... - How can I check if old scope still occupy DHCP lease or not ? - If added scope, expect it get a...

Is there a way, whether using SNMP or directly from the router, to monitor the ESP bandwidth (total output bandwidth of the system regardless of the direction) on an ASR1001-X?

Are there other products that provide modern protections & monitoring capabilities as well as inspect GE protocols like SDI and EGD? Can ASA be used at Layer 2 for SDI Traffic?  If so, what does that rule look like?    

(answered) (internal mistake not relevent)

  how to fix configure layer 3 switch vlans with xg sophos i have configuration in layer 3 switch is created 6 vlans : my vlans ip address is: vlan2 : 192.168.2.254 255.255.255.0 (servers) vlan3: 192.168.3.254 255.255.255.0 (Workstations) vlan4: 19...

I have a doubt in using regexp in my eem script.    Can someone help me.   My Script: event manager applet update-port-description event neighbor-discovery interface regexp GigabitEthernet.* cdp add action 1.0 cli command "enable" action 2.0 cli com...