Network Management

As of this point we don't have an NTP server so I have set the clocks manually. I have noticed though that this is not a good clock as if the switch reboots it is lost. I have tried using the calendar command to set the hardware clock, but no luck. I...

I don't have the options to configure port security on thw switchports in my 2811 ISR router.  When I type "switchport" when I'm within interface config, there are no port-security options. 

Hi, We are using Cisco Prime for monitoring and managing wired and wireless campus infrastructure. Wanted to know if we can monitor non-cisco devices (IP Cameras, Automation systems, etc.) using Cisco Prime 3.1. If so, how does the licensing work ...

Dear Colleagues, I am trying to capture packets in remote location by utilizing Embedded packet capture on router. My idea is to bring the RSPAN VLAN to specialy created L2 subinterface on Router and apply the EPC on it. (monitor capture point NAME ...

I am upgrading our switch to the IE 4010 from the 3750...I am having 1 error from my config file...as follows: interface Vlan3 description LAN ip address 192.168.30.253 255.255.255.0 ip helper-address 192.168.20.255 ip directed-broadcast ip pim spars...

We've just installed a couple of ASR1002HX in our network and want to manage them and run AVC in Prime 3.1. Seems the routers are not supported in Prime yet? Anyone knows about an ETA on a device-pack for ASR1002HX support?

Hello, I just creat two ethernet channel 1 and 2 and connect these port to my server and all ways, i got Gi1/0/22 suspended . please advice me, thanks  interface Port-channel1 description DHost switchport access vlan 10 switchport mode access no ip ...

Hi We have stealthwatch but we are handing it over to another team in the same office. Would it be possible to get someone out to check out the config and give some advice to the new team that will be managing it Steve

Hi Team, after Discovery i see the same Device withe Multiple IP Addresses, every address is valid. Does this Device assume more Token than physically needed and, is there a way to set all Addreses except the Devices Loopback Address to unmanaged, or...

I relocated a WAP 371 access point and it was and is setup as part of a cluster which is a single point setup.  This access point is now showing a steady amber led on the LAN indicator and before it was green. according to the booklet it indicates th...

Hi. I tried to upgrade our PI to v3.1 today, but it fails: Pre-install step failed. Please check the logs for more details. And the log says:Install initiated with bundle - PI-Upgrade-3.0.X_to_3.1.0.0.132.tar.gz, repo - defaultRepoStage area - /store...

Hi Anyone know when c2960L switch will be supportet in Cisco Network Assistant. Cisco IOS Software, C2960L Software (C2960L-UNIVERSALK9-M), Version 15.2(5c)E, RELEASE SOFTWARE (fc1) I have  version 6.3.0 installed ( tryed 6.3.1  ) Thyge

Hi , I  have setup a new Csico prim infrastructure 2.2 and restoring the backup from prime PI 2.1 . I am getting Error while restoring the backup . "Error while updating database schema, please check the logs.Please cleanup using command ("NCS run ...

Today for lab simulation I installed cisco prime 2.2 in esxi 5.5, installation successful but I am not able to login GUI of cisco prime, it   give an error "invalid username and password ". I tried the below steps: NCS stopNCS DB reinitdbNCS start ...