Network Management

Hi support,i configured netflow version 9 for a remote cisco 2911 for interface g0/1 and interface tunnel gre. In our netflow analyzer we receive the interface g0/1 but not the interface tunnel gre .can you explain me the problem.please see the versi...

Hi group,I have a cisco 2800 series router that I'm trying to setup for ssh access. The router is outside of the firewall. I've consoled in and setup ssh access and setup routing for return traffic. When I open a putty session, i can connect and ente...

Hi, We have cisco PI 2.2.0, I want to confirm that after installing 2.2.3 patch the SysOID will not change, thank you

Hi, Can we change the MTU Size of Prime Infrastructure 2.2.0, does it support jumbo frames Thank You

What commandline should I use to install the software unattend and silently?I tried /s /v"/qn" or /s or /q with no success.

Hi; I have 1142N Cisco aironet. I cant access to this device, actually I cant make configuration. i used console cable with Ethernet cable to setup. steps which I used: AP>en AP#configure terminal   (I am stuck here) in this point the system doesn't ...

What is the difference between switch with PFC capabilities and switch without it? because apparently the end device sends Pause frames right?

This question is for people that use Cisco Prime's plug and play to configure switches at remote sites, this is Prime WITHOUT using the APICS-EM. I don't have much issue with pre-provisioning the new switch in prime, the question I have is what port ...

Hi All, We are having a problem with the WAN performance reports in Cisco Prime 3.1. When we run the report with any criteria we get a message saying that there is no data available, this happens regardless of which devices, data sources and time pe...