Network Management

Hi Currently, I am using windows 2008 to act as radius server for the network equipment, but I am stuck in the cisco WLC 5508. The situation is that I am able to login routers, switches, wireless clients with using the radius server. For the WLC, I c...

Hello All, We need to enable card down trap on cisco 7k switches to send it to HP NNM (NMS) server so that when there is issue with card ,NNM identifies it. Now once card down trap is enabled on switch , i have to enable snmp trap configuration on (...

When trying to answer questions about which cable is connected to which port on my asr9k, I'm struggling to figure out how to show the mac address on the other side of a port for identification purposes.

Do the SNMPv3 requires defining views? As far as I understand with views you can restrict what the SNMP user can access. What is the behavior by default? What if I define only a group and a user? What access do the user will have?

Hello, I have flexible netflow configured for ipv6 like this: flow record ipv6-hor-ror-router-1 match ipv6 traffic-class match ipv6 protocol match ipv6 source address match ipv6 destination address match transport source-port match transport destinat...

The script is triggered but  changing the ip nat source interface is not working.Any suggestions 

hi guys, i am planning to get a new SNS 3495 hardware with ACS software and based license, CSACS-3495-UP-K9 Upgrade to Cisco Secure ACS application software on the Cisco SNS 3495 appliance with Base license from previous versions   CSACS-3495-K9    ...

Hi guys, Can someone help to advise us asap on how the based-license endpoint quantity are estimated?   We are confused the following FAQ in the pdf file below. What license SKUs should I order if the endpoint deployment count falls between differe...

Need help on how to discover the devices in cisco prime ..? what are the confirgurations needed in the switch, controllers Did the following but still get the devices as unmanaged in Cisco Prime Infrastructureusername CISCO privilege 15 secret cisco@...

All,  I am running into issues when retrieving Hex-String Values from IOS switches with perl, snmp_utils perl module, and net-snmp. For example, when I walk the following OID 1.3.6.1.2.1.17.4.3.1.1 on a particular Vlan, my result is literally "180.20...

Does somebody know working grep command in IOS.sh ?I experience no output with TACACS+ Authorization, "show authentication sessions | grep -ie 'gi' " with a command authorization failure, the option -v never works, "show run | grep  -i 'interface'" o...