Network Management

I am following the procedure outlined in the 3.0 Admin Guide (pp. 52-53) to generate a new CSR file. Does anyone know how to ensure that the key generated is 2048 bit length? I was unable to figure out how to ensure the key length and I was not sure ...

Hi,I am running PI1.2 virtual appliance (on ESXi 5.0). i had some issues and open a ticket to TAC. the TAC engineer requested me to send him the below:/opt/CSCOlumos/logs/failed_inventory_feature.log/opt/CSCOlumos/logs/ifm_inventory.log...My question...

Hi, On a few occasions we have experienced issues with a stack switch where it has failed. The problem is Cisco Prime 2.2 does not notify us because the stack IP address it still contactable. The stack does produce a syslog but it is only an informat...

Hi all, I am looking for the MIB value to identify the IP, VC, Policing, VLAN from the config below : interface GigabitEthernet9/14  mtu 3000  bandwidth 100000  no ip address  storm-control broadcast level 0.10  no keepalive  xconnect <xx.xx.xx....

Hi Guys, Its great to be able to show a non Cisco guy what a network looks like via the topology options in Cisco Network Assistant, but the 6.2 version is quite outdated. Any idea when we will get the new version? Or know if Cisco is still doing d...

Right now, when a member of the stack goes down we are not aware of it . I'd like to send an email whenever a stackwise snmp trap arrives at LMS ( using Fault Notification Group ) 1- I've just enabled on the switch to generate the STACKWISE traps: s...

  Hello team, do i neeed Security plus license on ASA 5506-X for dual ISP support Kind regards Max https://communities.cisco.com/thread/55870?start=0&tstart=0 Definitely not clear on the 5506 (compared to the 5505).  Since all the ports on the 5506 ...

I 'm in the LAN, I know my LAN IP, how would i know what is my external IP(WAN IP)? using ipconfig /all, i only see my LAN IP, i'm using windows 7. I can't install third party tool to view my external IP.

Hello I'm new to Cisco Prime and to get started with it I tried to run a simple report about CPU Utilization on a single device from our 2.2 Prime installation. Devices were already configured prior to my attempt. I went to the Report Launch Pad wh...

Hi, In PI3.0.2 I can't found how to setup the polling interval on the devices for the ICMP Reachability Status. By default a Ping is sent every 5 minutes but this delay is too long and I want to reduce it to 1 minute. I've tried to modifiy the parame...

I have a appliance running Prime Infrastructure 2.2, I have backups that ran and completed in the defultRepo Repository.  Everytime I try and FTP a backup to a remote location it fails, with the error Backup file trnsfer failed due to invalid config...

Hello Experts,   I am using MRTG software to plot the link utilization of my Nexus 7K switch. However, VLAN interface utilization is not getting plotted. While all the other port channel and physical interfaces are getting plotted. Is there any known...

We have an existing Cisco network and I support 1500+ IP phones that are on it. None of our switches ever had QoS enabled. Since a recent network design upgrade we have been experiencing call quality issues both internally and externally.  Can anyone...