Network Management

I have an issue with Netflow that I have been unable to solve. I have an ASA5510 that is sending netflow data to a FogLight NMS and it works fine until I reboot the server. After the server is rebooted, the flows no longer are received until I reload...

is that possible to remove DFM and IPM from LMS 3.2 I have never used and LMS appears to be slow and i am thinking  trimming some unwanted apps may help. thanks.

I have a Cisco Works server that appears to be backing up config files from the routers.  If I needed to restore a startup-config, how do I do it? I tried "copy tftp start"But I have no idea what it has named the file, where it is stored, it appears ...

I have an easy problem that I'm obviously over looking.  I imagine it's been asked before.I've downloaded the multiple pipe support script, copied it to flash, used the event manager policy cl_multi_pipe.tcl command.  Then I get an error:EEM configur...

Is anyone aware of any tools or scripts out there which allow preconfigured commands to be remotely run again Cisco Router/Switches and display the output result?I'm looking for a tool which I can give our Service Desk personnel that will allow them ...

HelloAfter update to LMS 4.2.3 is get always a message to confirm when login:"Server is capable for performance tuning. Please enable PTT ...."            Even when i setup PTT the message will come again next time i login.The message comes also seve...

After defining default credentials (for SSH, SNMP, etc) I created a standard discovery job and specified a seed device.  The job immediately found the seed device and then proceeded to discover all of the downstream devices (10 total including the se...

Hi,I'm running LMS3.2 and RME 4.3.1. I deployed a netconfig job to our network which consisted of approximately 800 devices.The report said that the job completed successfully however some of the devices didn't save thier running config to startup. H...

Using LMS 3.2, I've started learning how to use the compliance templates. I have a question regarding the regex matching, and I can't seem to findan answer in the docs or in the forum posts. I do admit that I have not dug real deep in the forums.My q...

Hi NMS community I just installed PI 1.2  in the Lab.PI is of course also a trap receiver which get in traps with a community,Where can i configure the trap community for Prime ( not the one for the network elements ) ?ThanksKarl

Hi all,Sometimes we have unidentified traps in our log, we don't know where they come from. In high severity faults we see an active alert with device name “Unidentified” event name unresponsive but with a certain ip address. What are these alerts ab...

I need your help to get starting the configuration of Cisco LMS v4.2 , i have already configured all switch and all routers with SNMP . I need a steps to configure LMS server v4.2.