Other Collaboration Subjects

Call Manager Access Resolved I found some instruction to press I and enter the "Interactive" mode after a reboot. I could not get the procedures to work because it scrolled by so quickly. I hit the "Scroll Lock" and that slowed things down and allowe...

Hello all I am in the process of rolling out MRA for our organisation and since we have an existing WebEx Messenger service that users are familiar with and use extensively to communicate with partner companies I have decided that a hybrid MRA soluti...

Looking for the right firmware to load on CME 10.5 in preparation for the installation of ATA 190. 

First off, Please read fully.Second off, I don't have a lot of experience with cisco IOs.I have a cisco 2821 that all our voip and fax calls get routed through. Can I setup the 2821 to automatically detect which incoming calls are fax calls and autom...

Dear All , i have cucm 10.5 which has ICT trunk with other company CUCM 10.5 too ,we have site code 66.XXXX on each site and All calls to and from is working fine , Except when the SNR working . when ipphone from Company A , called IPphone in Company...

Hello,I am having BE6K CUCM, CUC and IMP version 10.5.X.i am looking for solution in system with that if any changes happened to current running configuration, system should provide the notification to admin user.would be this setup possible with in ...

I have installed Jabber Version 11.0.1 and version 10.5.2 on the Call Manager and Presence, and the option Click 2 Call is not working anymore after upgrade it. Before was working the option Click 2 Call with jabber Version 9.2.2.For this reason I ne...

Hi Guys, I'm triying to make a call pick up group and I'm having that error, I'm using a 7940 and 7960 phones, and using a 500 license, This is just a lab because I'm studing for the ccna voice certification. I uploaded a picture

We've put together a Use Case Tool for you to see how you can increase productivity through collaboration. Use the tool to enhance your company’s revenue opportunities, shorten sales cycles and boost your competitive advantage. Learn about collaborat...

Hi,All IP phones are registered with Subscriber but when i checking the extension details in CUCM. Device > Phone >  In the Status and IP Address section is showing UNKNOWN whereas in IP phone IP address and Actice and Stadby Unified CM are showing. ...

Not sure if the software version within the Systems Information Overview is the same as the Firmware version... Please advise! Thanks!

Hi All,Can anyone assist in helping to configure specific extensions at a branch to make calls over WAN(T1 lines) while the other extensions use the local FXO lines for external calls. The extensions would require a code to dial out whether over the ...