Other Collaboration Subjects

After installing exchange 5.5 (with sp4) on win2k sp2 machine. I try to run setup for unity 2.4.6.135 but alway get a abort message indicating "ldap is not enabled on the exchange site". I check the exchange setup but it was already enable. Please he...

I would like to propose to an ISP client to use Cisco3661's with a total of 6x NM-HDV-2E1-60 2-port E1 Voice cards into each chassis. This mean that the Cisco3661 will be fully populated with 12x E1 VoIP gateway ports each.Is this a workable solutio...

We have a system with IP/TV content manager, IP/TV servers and IP/TV viewer. Version is 3.2. In the system there are also two filing servers with a capacity of 24 hours and 250 hours. In the filing servers there are the "IP/TV server" software.In ter...

I am installing a t1 pri line from our router to our Definity G3 .I'm currently having sync problems.LAYER 1Can anyone supply me with the configs of a working PRI gateway that is not controlled via MGCP.I would also like any configs on the G3.Thanks

Hi,I have CCM 3.1 and a PRI connection (6608) to a PBX.For example, my regular phone is 8111 and an ip phone is 4111 . I forward all calls from 8111 to 4111 . When I call from any regular phone to 8111 I do get the call on 4111.But if i call from an ...

I found documentation from PictureTel or Accord are really poor. Anyone know where to find detailed technical documentation for MCU/PictureTel Endpoint? thanks

I've a CCM with IP-phones and a SRST gateway (3620) with PRI E1 access to th PSTN. To access the PSTN a 0 is dialed in front of the called number and on the CCM I use the PreDot to remove this 0 before I send the number to the 3620.On the 3620 I've ...

Is there any IP phone (7910?) that will support h323 without the call manager? Thanks in advance.

I have been attempting to install the Extension Mobility Service on a CallManager 3.1(2c). I have configured the service as outlined in the 'Configuring Cisco CallManager Extension Mobility' document. When I log in to a phone I enter the UserID and...

Here is a strange one... I have enabled music on hold on my callmanger 3.12c system and it works just fine internally. I have CRA 2.2(1) installed to use the ICD application. If I enable music on hold for my gateway (a 2610 with a pri), then the ca...

Hi,I'm trying to install CCM 3.1 on Netfinity x340 server with RAID but it seems the Win 2000 cd (disc 1) doesnt contain the correct driver and the installation stops in the beginning with lots of error codes. When I take out the RAID i dont have thi...

I was hoping to install Call Manager on a test machine in our lab, to stage configuration changes before implementing them on our production CM. I was told that there might be a away to stage CM on a seperate WinNT machine.Does anyone know the proce...

Hi,<br><br>I have a question on Unity 3.0. Do it support mutli-level of administration?? In subsrciber, there is a COS. How's about on administrator??<br><br>

Hello,I configured a 2620 router with BRI S/T TE and NM-2V voice module for VoIP applications using H.323 gateway and gatekeeper. The router runs with IOS 12.2(3). When estabishing a call from a H.323 phone to the ISDN network the Q.931 SETUP message...

I'm configuring two 2621 routers for VoIP over frame relay and I would view how many of bandwidth are consuming every call.There are any command that show me this consumption?