I am trying to setup Call Attendant Console for our receptionist however I am getting "Initialization of Call Control Failed". Please help! P.S. I have two receptionist one is working the other is failing.
I am trying to setup Call Attendant Console for our receptionist however I am getting "Initialization of Call Control Failed". Please help! P.S. I have two receptionist one is working the other is failing.
Assuming its a 220k wmv 8 live event.PC would have to WMV 8 codec but what is general rule for CPU and RAM.Is there a customer facing doc?
Hi,I have a CUCM Version 7.0.2In the Device Defaults I had ATA030203SCCP051201A for Cisco ATA 186.I loaded ATA030100SCCP040211A.zup into CCM.In the device phone I changed the "Phone Load Name" to ATA030100SCCP040211A or ATA030100SCCP040211A.zup, save...
Hi there,I'm trying to configure VoiceView on CME/CUE 7.1 but I'm running into a roadblock. Whenever I press the services button on the phone, I receive the "Host not found" message. I've tried using the IP and DNS name in the URL config, but neith...
Hello,Is there a CDR reporting tool that can give detailed reports on trunk utilization (they are used to CCS reports from Nortel switch).Thanks
Hi,I have ECOTEL VoIP GSM GW and Cisco Call Manager 6.1. GSM GW is upgraded to the newest firmware version (5.1.13) and I tested some features like adaptive callback, call on hold, transfer,... For the most of this features you need to dial some digi...
Hi,I erased the config on a 7965G and could not get it upgraded on CME.In telephony-service I specified load 7965G SCCP45.8-3-3S but i get a error message, the only thing i could do was load 7945G SCCP45.8-3-3S.I do not see any SCCP65... files either...
Good Day,We have CCM 4.1 configured using MGCP located at our colo with ~10 sites running 2800/SRST routers. We have a issue with 1 site where the incomming call is intermittently not arriving at the pilot in question. When we receive the complaint...
Can someone tell me what this term means? My guess is the number reflects the incoming calls that go either to a live agent or to voice mail. Can it reflct any other scenario? (Calls diverted or dropped)?Thanks
my 7905 ip phone needs the latest firmware yet i am unable to get a tac or a partner to get it for me i am stuck can some one help
Hi,We are currently using Cisco Unified Call manger ver.5.1.2If I have my office Cisco phone enabled call forwarding to my cell and I am on the road, is it possible to remove the call forwarding from my Office Cisco office phone remotely? (Without lo...
I know I may be beating a dead horse, but I've found so much help in these forums that I figured I'd give it a shot.We have a Cisco Unified Communications Manager Business Edition and we are running into a configuration issue. What we would like to ...
Dears,I have fax machine that connected to ATA 186 and the ATA registered on Cisco Call manager 4.1(3), may issue is the Fax can send the whole paper for local faxes (in the same city), but if when I send fax to another fax with long distance (in oth...
HiI've a Faxserver connected over SIP to a Cisco 2851 and I'm not able to send faxes. The ISDN connection to the PSTN works fine, but is teared down after a few seconds. Find attached the relevant configuration, a debug voice dialpeer and a debug ccs...
Hi to all,i have a call manager 7 and i want to add ip communicator on the customer pc.I have buyed the license for all the pc but i want know if i need to buy the software for every pc or if i can use only one software for every pc.Thanks and best r...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-23-2024 11:56 PM | ||
08-21-2024 05:48 AM | ||
07-17-2024 05:55 AM | ||
07-15-2024 12:39 PM | ||
07-09-2024 04:24 AM |