Other Collaboration Subjects

We currently have Call manager 6.1 (linux based) with a Publsher and Subscriber sitting in our cluster. I am attempting to set up a 7940 (2 button) phone in a lobby type area. I want only the two buttonson the phone to work as speed dials would, bu...

Hi There,I have a 2610 router with a VWIC-2MFT-T1 card installed. The IOS is: c2600-jsx-mz.122-46a.binwhen I start the router, I see that the voice card is detected but then when I do a "show run" I do not see any voice port or interface etc. I can c...

Hi all,In our company we have two callmanager Clusters ( Site A 4.1.3 ; Site B 6.1 )Before we did an Upgrade on the one site we could use the directory from the other side as well as our own, but since we did the update the users can only access thei...

Greetings, is it possible to configure a CME system with both an ISDN and SIP connection, Using the SIP Service for the primary source of inbound and outbound calls and have CME failover to the ISDN should the IP Connection to the SIP Proxy fail?I kn...

All,I'm making my first attempt at installing Unified Presence ver 6.0.3 on an ESX 3.5 Guest VM. I'm able to get all the way through the installation up until I get a "Failed to get Trusted-Peer validation" from the CUCM (ver 6.1.2) Primary Node. I'...

Where do I find the timer to change when A all goes into voice mail box and then they hangup. Customer does not want hangup calls in voice mail. Is there anyway change the timner on this?

Hi there,I'm having a problem with one port in an ATA Box, I can receive calls properly from any internal and external phone but when I try to call from the phone connected to port 2 in my ATA I get a busy line signal but the line is available. The p...

Hi! I develop idle service for 7941, everything works fine. But I have problem, users are accustomed to first dial the number on the keypad, then press the call. When the page is displayed on the screen, dial impossible. The keyboard is blocked. Can ...

Where do you find an version number for any ATA? Trying to determan the correct software version and if i have the latest.

All,We are running call manager 5.1. Today at our corporate office we use 3 digit ext. and need to switch to 4 due to over lapping numbers with branch offices having 4 digits. One question that has been asked is we will know if someone is on their...

I'm using Anyconnect VPN with a 3825 and the VPN comes up and works well with data however, IP communicator is not fully functioning. Using CME 124-15.XZ1.IPC registers and lines appear correctly. Services button works. Directory works. IPC is se...

Hi!I have configured a software MTP on a Cisco 2801 router with IOS software 12.4(13r)T. Unfortunalty it doesn't want to register with the Call Manager. Here is the configuration:-sccp local FastEthernet0/0sccp ccm 172.31.120.10 identifier 1 versio...