When we try to access CAR, we get the following error: LDAP access error. See Administrator. I went into the DC Directory admin and made sure we are using the correct username. I also checked the registry and the password value for this matches t...
We're considering a Cisco IPT deployment and just ran across a new PoE switch from Dell that is 33% of the cost of our already-discounted Cisco switches. I'm curious to find out what you all think: how colossally stupid would it be to run Cisco IPT o...
Hi,how can I migrate EM profiles (and other user information: PAB, ...), stored in Active Directory server to new server in a new domain without retyping them manualy? Will Microsoft migration tool do the job correctly? Has anyone done this? We have ...
http://info.connect.com.au/docs/routing/general/multi-faq.shtml((How do I configure BGP so that bad things don't happen?))Does the command "ip as-path access-list 1 permit ^$" from the link above, stand for a null path (^$) ?
I have got the scenario below :R1router ospf 1 redistribute bgp 200 subnets route-map BGP2IGRP-------------------ip prefix-list BGP2IGRP seq 5---(I omitted the rest)-------------------------route-map BGP2IGRP permit 10----I omitted the restIs it mand...
Hi All,Can anyone tell me the difference between 7912G and 7912G-A IP Phone? What do i need to do if i want to upgrade my IP Phone from 7912G to 7912G-A ?Regards,R. Rajaraman
Hi,We have VG224 to which we have connected analog phones.For some phones(or ports) on VG224 when we dial another analog phone connected to another VG224,the other phone rings but gets disconnected when answered.This is happening on more than one VG2...
Looking for a good QoS policy to apply on WAN links for CM 4.1(3) SR1 Publisher/Subscriber communication. I recall only that bandwidth required is about 982kbs. I'm looking for a specific policy for standard CM services (all but Messaging Interface, ...
One of my remote offices only uses 7-digit dialing. When the receive an incoming call and it logs in the phone directory (missed or received) it shows up as a 10-digit number. If the call is a local call, the user has to press "edit-dial" add the 9 a...
Hello,I have a MCS-7825-H1-IPC1 server and I saw that MCS-7825-H1-IPC1 requires OS 2000.4.1 (http://www.cisco.com/en/US/partner/products/sw/voicesw/ps842/prod_release_note09186a0080310dd7.html)Is it possible to install for example the 2000.2.7 or 200...
Hi,On my 7960, when I redial a long distance call, from the missed calls directory it fails. If I physically dial the same number it works.A solution will be apprecaited.Thanks - Tennisman.
Does anyone know if the WS-X6600-6T1 can be used to terminate 2 T-1's and the rest of the ports set as transcoding resources for conferencing in CM?I can't find the docs for this.Thanks in advance
Direct Inward System Access... I know on my old PBX we could do this codes, etc... I know this opens up toll fraud, etc.. but with a code, it's tracked and given out then. Can this happen with CallManager?Thanks much!Tommer
