Other Network Architecture Subjects

Just a sanity check for a customer.If I have a frame-relay shaping statement on the main serial interface that is shaping to a T1 and then have different shaping map-classes for some of the interfaces, which will prevail.Key point that the customer h...

hi, recently,there were some error messages present to console when our 7507 boot up. here it is"%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader. boot of "cisco2-RSP8" using boot helper "slot0:rsp-jsv-mz.122-8.T.bin" failed er...

Hi,my 2950T-24 needs about 10 minutes to accept my new ip addresses, when I remove the IP address A.B.C.D on a computer 1, and configure it on a computer 2, both already plugged on the switch. During this time, this address is unreachable (I can ping...

Hi there,Is there any way to turn on displey of egress frames going out of the token ring interface?I'm running 12.2(15)T9 on my 2612 router and when doing debug token ring the output shows only packets incoming the interface. At the same time I know...

Here's a quick diagram of what we have: Cisco 3508 (Distribution) | | 1GB Fiber connection | HP 4000 (Access)Are there issues to be concerned of when interconnecting a cisco switch to an HP switch - i.e. spanning tree, tr...

Hi all, i've some problem with my multicast flow.If i use mtrace command from side A to side B all is Ok, but when i do mtrace from B to A i see this outputSource address or name: 10.10.50.8Destination address or name: 192.168.65.100Group address or...

Hi,I am running ciscowrks and like to know what is the easiest way to have all my devices on the network in the resources manager.Thanks in advance

I´m looking for an overwiew of the default settings that are not shown in the config of the IOS version 12.Thanks!

I remember seeing a command to configure a port when connecting another Cisco switch. This command allow you to avoid using a x-over cable to connect the switches. Similar to a "midi" switch on a media converter or an uplink button on a workgroup s...

Hello, I have 7206VXR router with NPE400 processor module.I need place in this router I/O controller GE+E module, PA-2FE-TX and PA-GE module.If I do bandwith calculation, with whatever HW configuration result is, that bus BW is oversubscripted.Questi...

I need to limit traffic on my inbound T1 lines destined to one address/node. I've read lots of info but still don't know which way to do. I would prefer to say just limit it to (ie) 10% of avail bandwidth, or even hardcoded figures. Also, I'm not s...

Hello,Can someone send the link for secret password recovery procedure in Cisco site for 2950C switch . I'm trying to search , but it does not produce the required link.Regards,Raju

I have a serial link (running frame-relay) that continuously has interface resets on it. I am not counting errors on the port so i am confused as to why this is happening? Any ideas.Cisco 3662c3660-is-mz.123-4.T2.binSerial1/2 is up, line protocol i...

Hello,I have a problem with some of my 3550Whe I do a show spanning-tree uplinkfast : The "Number of proxy multicast addresses transmitted " increase really fast and it's not normal, does anyone have an idea ?So I have lot of unwanted traffic in my n...