pls help me that how can i make my cisco 2522 series router with IOS 12.0 to become Frame-Relay Switch. Pls tell me the procedure to make it frame-relay switch.
HiCan someone please explain as to why you need more than one process ID in OSPF, please? I mean what's the use of configuring another process ID in the same router?Thanks in advance!Omal.
I want impelemnt route for network 62.111.111.xthis network was conect to the pix and the pix is connecting with my routerand my router has two interface S0 connect with my ISP ip address 10.x.x.18 255.255.255.252E0 connect with the pix ip address 17...
6509 IOS ver. = 2.2(17a)SX3The 6509 ports g2/1-12 are in vlan1 and are switch ports. IGMP shows as enabled at the vlan interface but not the port/interface.interface GigabitEthernet2/1 description link to 49.128 subnet via 1924/B no ip address speed...
Hi,I now work for a company that is AFRAID of subnetting, and for every site they add,they pick an 'illegal' class A addressand use the default mask - and that's itfor the entire site. IP unnumbered forWAN links.(changing to something reasonable is N...
I want to know that for what purpose we use dialer rotary-group command in interface mode. What is the differnce between dialer pool-member and dialer rotary-group command.
Hello does anyone have a mrtg config that theya re doing both CPU monitoring and memory monitoring. Could you post or shoot that over to me ?.ddube23@yahoo.comThanksDavid
i currently have 7 different vlans in use sometimes there comes a time when i need to send files to all of the pc's at the same time, so how can i do this, i suppose tagging is one way put with that one port can talk to all of the vlans how do i rest...
I had been trying this for a long time now, but still unable to find any way. I am connected with 2 back bone service providers. I have 8 IP class assigned from APNIC. I want to advertise 4 classes on one network and other 4 on other network. But whe...
Hello,Can someone help me to understand the buffer failures we get in our 3750? How do you adjust these buffer settings?The failure increases with about 5/secsupervisor_cpuq_2_pool buffers, 2040 bytes (total 64, permanent 64): 0 in free list (0 m...
Dear allwhat is the address that I write in the internet explorer (http)to open the configuration for the router java is installedI want to know the address
Hello there!I have CAT 3750, version 12.1(14)EA1a. I used to apply a standard access list to line vty 0 4, for restricting a management access, and it functioned fine. But recently I had to change the ACL, so I killed existing ACL without previous re...
Is it posible to have a hub and spoke arrangement, whereby the spoke sites can connect to each other via the hub site using dialer profiles. The spoke sites can connect to the hub site with no problems and pass IP onto the LAN at the hub. I cannot ge...
Hi All,I went through the posts in this forum, but just want to make sure about 1) Am I right in saying that if I configure a DHCPpool for each VLAN, the switch will know which poolto use by looking at the incoming interface? 2) I cannot seem to get ...
