Other Network Architecture Subjects

I have several devices 'stuck' in either Suspended or Not Responding. Whenever I attempt to delete these devices I get the error A failure occurred during an import status operationWhen I click Details on the error screen I get the following messageP...

Could someone please refer me to where I can read up on the arp caches?Thanks

Cat 2980 Support IOS ??

I am interested in using multiple T1 connections with my Cisco 2600. I have a couple of questions regarding this issue.Can I get a Multi-port T1 card for the Cisco 2600 or use multiple T1 cards? Which is better?Will the Cisco 2600 "bond" the connecti...

Hi,Has anybody configured pppoe on a cisco 1720 router? if so can you send a typical config for this, I would really appreciate it..Thanks.

HiI am having a problem on a 1601 router on a remote site in a frame-relay point to multipoint network. There are currently 9 working remote sites where the routers are forwarding DHCP requests to a central DHCP server except the one 1601. Any ideas ...

I could not find this information on Cisco web siteCAT4006-S1> (enable) sh verWS-C4006 Software, Version NmpSW: 7.4(2)Copyright (c) 1995-2002 by Cisco Systems, Inc.NMP S/W compiled on Oct 8 2002, 18:12:59GSP S/W compiled on Oct 08 2002, 15:54:51Syst...

Guys,Does anybody know?If a router is sending an snmp trap then the packet contains 3 IP addresses.1-destination2-source3-Agent address The Agent address (device ID) for this trap is most of the time the same as the source address.But....this is not ...

We added a 2nd point-to-point T1 connection to our 2650XM router that goes to a Nortel BLN (Backbone Link Node) Router. The problem we have is that once we add the second T1 to the multi-link PPP group, all traffic stops routing. Has anyone seen anyt...

We used to boot out workstations with PXE boot but since we have implemented VLAN´s with ip helper adresses the workstations only get an IP but whrere not able to connect to the PXE Boot Server on Port 4011.I have sniffed the communication an saw a d...

I'm setting up an IGX 8410. Whats the default user ID an password?.When booted, it asks for a user ID and password. These are new units and documentation doesnt indicate any default username and password. Also during the boot process, at a point you ...

When I launch DFM Monitoring Console on client computer, I get Console Load Error that reads: "Could not load console alarm_log.iccon com.smarts.viewer.console. SMSchema Load Exception: <server name>". The function loads fine on the server. What's go...

I have a catalyst 2950 which is bought recently. The prompt command does not seems to be there. Any idea. The cisco version is 12.1.(14)ThanksAgnelo

May sound silly but is it possible to configure etherchannel with 3 ports (or with port numbers except 2,4,8)?And in case of a 4-port etherchannel bundle how does load-balancing algorithm work in case one link fails?Regards.