Hello everyone! I'm trying to set up an 1721 with 1ENET and 1-BS/T. The 1ENET is used to set up a PPPoE connection to your ISP. I need to configure the BRI/Dialer Interface to Backup the PPPoE-Connection. The complete sceanrio looks like this: PIX501...
This was announced back in March - any update on when it will become available?Also, when will newer versions of 12.2(14)SX provide Sup720 support for modules like the 48 port 10/100/1000 modules?Thanks!
I have a customer that has a 2621xm router, 12.2.13 IP/FW software that has a MLPPP bundle with two T1's for Internet Access. Everything looks great, good throughput. As soon as he is using ACL's and CBAC on the Multilink interface, the throughput is...
Hi,We are getting this error whem booting Catalyst 6509 SUP2/MSFC2 running CatOS 7.6.1 + IOS 12.1(19)E.2003 Dec 11 01:27:17 %SYS-5-MOD_OK:Module 1 is online2003 Dec 11 01:27:21 %SYS-3-FAB_CHNGMODE:System switching mode is being changed to compact mod...
Hello. Can you help me with the following task: There is branch office with Frame Relay connection to the Central site. There is one PVC with only one DLCI. Is it possible to encapsulate IP traffic and X.25 traffic in this one PVC using AnnexG sta...
Hi,I'm trying to install a 16 port Serial module, NM-16A/S in a 3745.Can anyone confirm what IOS I need for this module. All I need is IP Plus feature set.Hardware/software matrix say I need 12.2(15)ZJ or 12.3.2(T). I have tried both main versions wi...
Topology is a c7206 with ATM 0c3 in IP network with Point to Point VPIs within our private network. Our Telco was suggesting internet access via policy based routing and ACL through ATM VPI/subinterface over the FastE- then connect into the firewall...
Cisco newbie after some advice. We currently run a small network of around 200 pc’s and a handful of servers across a 193.xxx.xxx.xxx 255.255.255.0 IP range & subnet. Our gateway is on a vlan 193.xxx.xxx.1 which is connected to the rest of the buildi...
I am puzzled by a condition on my network. In some locations a static route for a segment prevents that router from updating neighbors with the segment covered by the static route. I would think that the topology database would still hold the route...
Is it possible to put more than one rate-limit on an interface so that I can use a Timeband to increase the bandwidth during the evening?Bandwidth restricted to 3.5Mbps as I have voip running on the rest of the 10Mbps link.I'd like to increase out of...
Anybody who can help me how to interface the routers 3745 to the existing routers 3660 all are connected via leased line and some are connected via fiber optic.Is there any difference configuration between the two different routers. Please be adviced...
I would like to run a command line utility to create a custom Audit report dumped to a csv file on a periodic basis. Is there such a utility available? How might I accomplish this?Thanks,RickB
No matter what way I add devices (import with CSV/DIF or manually), every device ends up not responding with the following error..."Could not commit groups and annotations"I moved my CW VMS to a new box and know that the devices are responding ok to ...
