Other Network Architecture Subjects

Hi !I am trying to dialin to a CAT6000 switch console via a modem line.I configured the modem - using hyperterminal - f.e.: to answer incoming calls, disable flow-control and so on.If I try to call the modem it answers the call - everything seems to ...

Greetings,I have a little issue with a modem attached to a new router serial interface. I have a modem connection that worked until I connected it to a new interface. The modem was changed to be sure it was OK. The modem answers when dialed. The c...

Hi,I have a 12 gig ports switch that connects to several other switches (Star topology). I would like to know what switch is on what port. Is there a way to do it without unpluging each port (causing the closet to go down) to track the switch on t...

How to push passwords using cisco works 2000 4th edition.Especially for catalyst 4000 series switches.RegardsMudassir.

i want to block piolet (File Sharing Program)which uses a range of ports 10240 to 20480how can i block the port range?

what can i do?the config is erased,and no vlan can be addedhelp me thanks change the ios ???

What is the bottom line regarding hard coded settings versus "auto" settings for LAN speed and duplex. I have heard valid arguments for both sides...

I'd like to know what difference is between "LAN" and "WAN" GE port on this card.I'd like to use this card in MPLS/VPN PE router. Two GE ports to P routers and four to CE's. Is this scenario supported?Petr

Dear sir,My router is cisco 7507 and ios is rsp-pv-mz.121-18.1.E.My router met a vip crash a few days early."Aug 8 23:10:46.084: %RSP-3-ERROR: MD error 0000008000004000-Traceback= 40404034 40404750 40404888 40405C54 403CA6D4Aug 8 23:10:46.088: %RSP...

i want to know whether there is a restriction for the number of routers in one area. especially in "area 0".where can i find a documentation to explain the question?thanks.

Hi I am having a problem on a 2522 with 2 dialer interfaces associated with a single BRI.The first dialer interface is setup for dialin and the second dials into a remote site with a NAT overlaod.The problem I am experiencing is that when you dial in...

We have an dialer interface that occassionally sets up a call for no apparent reasonI wanted to issue a "debug dialer" command on this router and send the output to a file so that the next time this occured I could find out what protocol is causing t...

i have 1 2514, 2 2501, 1 2511thanks a lot

I got a 3550 SMI Multilayer switch and 2950T series switch.I have done configure both of the switch as Inter-Vlan Routing.The result was successfull.My question was is it posible that Vlan can access,(ping,network neighbourhood,telnet,etc).FYI,the Vl...