Is anyone aware of any other companies that make GBIC modules. Are these recognized by Cisco? I know that Cisco GBIC's are around $500.00. All suggestions are appreciated.
Please does any know whether it is possible to configure dialer watch on an etherner interface. I want to see if it is possible to use dialer watch to configure backups, using ethernet interfaces.Thanks
I need advice on the IOS that can support the following:1) SNMP version 22) Support SSH remote connectionBelow is the list of all the routers and switches that we have. Unfortunately we dont have a maintennace contract.2511------Cisco Internetwork Op...
Hi all,Does anyone know what a SW error 2051 is on the BPX and what causes one to occur? I have pasted the SW error snapshot below if you can also decode it!Also if anyone has a listing of other BPX errors, which identifies the catalyst and the recom...
Our telco is providing 56 t-1 across 2 channelized DS-3s. We terminate the ds-3's into adtran atlas 800's Then we map the T-1's out individual t-1 ports. We connect these individual t-1's to an 8540 with C85MS-8TI-IMA's installed using t-1 cross-ov...
I want to move away from RIP v2 run OSPF. Can I run both those protocols at the same time on the same devices then one at a time stop running RIPThanksAl
Hi all,Please I have connection to the Internet using a VSAT on DVB platform. I use a 1700 series router to link my LAN with the Internet. A Satellite MODEM provides the serial link. I recently noticed that my link is very slow. When I did a Show int...
I have conlosed into a 2600 router and attempting toto break the power-up sequence of the router to put it into ROMMON. The "break" key does not seem to be working. Does anyone happen to know if there's any other key combination that I may try?Thanks...
is it possible, when configuring a crypto map to set a secondary peer (under crypto map configuration options), for when your main peer goes down. Or do you have to configure a second crypto map. What is the best configuration option to encrypt my ba...
I have limited knowledge with Cisco Routers.. I understand simple Point to point Single T1 configs on 2600's but I have a more complicated Set up I need to deal with on a 3600.... the config is this:ip subnet-zero ! ! no ip finger ...
Hi all,i'm trying to configure a secondary IP-address on a vlan interface on a WS-C3548-XL-EN.The command is available, but it doesn't appear in running-config. IOS 12.0(5)XUAny suggestions?
Hi,Between a few routers and switches we have two links. All are up, working and support CDP. They are also showing up on the map but... some are shown as one link meaning they are drawn on top of each other instead of beside each other. I know this...
HELP!!I am trying to provide access from the Internet to a stack of cisco routers via their console ports for the purpose of educational instruction. I have students who need to be able to console into several routers and configure them as if they w...
I have two situations where the CISCO IOS has been updated due to the OSPF vulnerability. In both situations PPTP traffic has been disrupted and trace routing has been broken.
