Other Network Architecture Subjects

Hi, following an IOS u/g the ports connected to a TN 12-port 10BaseT to 10BaseFL rack show "not connected" (other link ports ok). I have replaced 2950 with an older one to restore service and all ok again :-( I had config'd the ports to 10M 1/2dx etc...

we want to implement the following scenario: We want all URL requests from our users (i.e URL requests to any random web site) to be redirected from the local cisco router to another specific web site. i.e if a user wants to access www.cisco.com, the...

network diagram:+-+-+-+-+-+-+ -+-+-+-+-+-+-+-+-+-+ -+-+-+-+-+-| W2K pro | -----| rtr2621withNM-8AM|---- | W2K pro |+-+-+-+-+-+-+ -+-+-+-+-+-+-+-+-+-+ -+-+-+-+-+-+ftp client Ethernet PSTN ms ftp serverapplication requiement:if ftp ...

Morning chaps,this is just a quick question:is it possible to run bri and pri on the same cisco3640 ? are there any problems and does anyone have a link to any relevant pages ?cheersRichard

Need help in setting up a router.....1. If i want to set up a router... what are the method to set it up.....What are the commands...2. should i write scripts...............to set it up.....like if i want to connect it to internet....or to some other...

Hello,I configured a Multilink Interface with two Serial Interfaces Ser1a-Ser1b and Ser2a-Ser2b. This Configuration works between 1 and 2 Days then no IP Packet goes over the Multilink Interface, in this State all Interfaces Multilink1a, Multilink1b,...

How do i load balanc between 2 catalyst 6509 with redundant link form client/server. HELP

A design question.If i have two core/distri switches, and 7 access switches, should i stack these access switches and connect the first one to core 1, and the last stack switch to core 2, or should i connect every switch to both core switches. What a...

We're looking at getting a T1 line between our home site and our remote site. What hardware would I need on both ends of it? Also, the home site has an internet connection that will serve as the connection for both sites. How would I need to layou...

This message is linecard fail,but we plug the line card to another cat6500 is normal.SYNDIAGS:Syndiags failed on Module #4. Use 'show test 4' to see results of tests.Module 4 : 8-port 1000BaseX EthernetLine Card Firmware Status for Module 4 : PASSPor...

We are running a 6509 with a Sup1a-2ge. The CAT IOS version is 7.6(1).We have just installed a WS-X6148-GE-TX board. When we move a workstation or server to this board, we can ping all other workstations and servers. But if we try to telnet to anyt...

Hello,I have a ATM moudle on 7400 connected to Alcatel DSLam. I am having lot of CRC errors.anyone has faced this problem?

Dear Sir,Can mobile ip supports on Catalyst 3550, Catalyst 4506 and Catalyst 6513Thanks.Regards,Delon