I am attmpting to configure an AS5300 to accept incoming calls from analog devices over an ISDN PRI and connect them directly to an IP device on the LAN side for data upload. I wish this process to operate without human intervention and, therefore, ...
Can anybody explain the difference between Ethernet autonegotiation and "port negotiation" on Catalyst switches (CatOS)? CatOS 6.3 reference manual for 5500 says, that "port negotiation" is only supported on 1000BASE (SX, LX, and ZX) modules, but I s...
I have a Cisco 4000 with Sup3 and an 8 port GBIC module and a 48 port 10/100/1000 module. Each gig fiber connection goes to a 3com switch in each wiring closet. All the servers and some PC's are connected to the 48 port 10/100/1000 module. The Gho...
Help!! my 801 router is missing its ios. i have hyperterminaled into it and it has presented me with a boot# prompt (which it does everytime). when i check my nvram settings my .bin file is not there. i have my ios backed up on a pc. how do i go ...
Doing a security check on our routers and recently having been informed on the "sh ip sockets detail" command, our 7140 router is listening on UDP/55072 and a second 7140 router we have is listening on UDP/56836. The remote IP for both routers is 0....
Hello,2501 is connected to DSU via s0 an V.35.DSU has ISP phone number stored and dials it automaticaly. There is no IP on s0 only on e0.Authentication PAP. My config:interface Ethernet0 ip address xxx.xxx.xx.201 255.255.255.252 !interface Serial0 ip...
If i use "show cdp neighbours detail" I see two 6509 with native IOS (all others catOS)with same IP address (127.0.0.12). On both 6509, VLAN1 and a loopback interface has it own IP address. Because there are two machines with same IP address for CDP ...
the Eigrp Neighbor is down very often, but the network link is always up16w4d: EIGRP: Neighbor not yet found16w4d: EIGRP: New peer 10.2.3.616w4d: EIGRP: New peer 10.2.3.716w4d: EIGRP: New peer 10.2.3.316w4d: EIGRP: New peer 10.2.3.116w4d: EIGRP: New ...
I have two bri cards - both worked in a 1700 series router but when I put them into my 2620xm series router and power up - i cannot see them. could there be a compatibility issue or is there something i am missing. thanks for any info.jenn
Hi, following an IOS u/g the ports connected to a TN 12-port 10BaseT to 10BaseFL rack show "not connected" (other link ports ok). I have replaced 2950 with an older one to restore service and all ok again :-( I had config'd the ports to 10M 1/2dx etc...
we want to implement the following scenario: We want all URL requests from our users (i.e URL requests to any random web site) to be redirected from the local cisco router to another specific web site. i.e if a user wants to access www.cisco.com, the...
Morning chaps,this is just a quick question:is it possible to run bri and pri on the same cisco3640 ? are there any problems and does anyone have a link to any relevant pages ?cheersRichard
