Other Network Architecture Subjects

Hi, is it possible to reference a peer-group as defined under the general BGP configuration in the address-family configuration e.g.router bgp 1 neighbor PEER peer-group neighbor PEER remote-as 1 neighbor 1.1.1.1 peer-group PEER neighbor 1.1.1.2 peer...

I need to configure single-router-mode and HA on 6509 switch with two sup I engines, can anyone give me any suggestion about the procedure? Thanks in advance!

Can you assign a port to multiple vlans?

I have been searching for a sample config for the CE on the MPLS. Could anyone please forward or point me to a smaple config.Thanks

Can you disable CEF on a 6509?ThanksMark Ayala

Using netconfig in CiscoWorks I cannot get a sucessful upload of the banner message. It appears that netconfig skips right over this part of the configuration. Has anyone run into this before?Thanks,Erik

Is it possible to to do a Copy running-config tftp from a switch / router and have my cisco works server accept it.

I am having trouble backing up the config for WS-C2950G-48-EI layer 3 switch using RME. All the other routers and switches are being backed-up. The Tacacs+ settings are correct since this switch is grouped in with switches, but I am getting a mess...

Hi, I have one cisco 677 provide me access to internet , and I want to conect five PC´s for access to internet, but I don´t want to use a proxy.I have configure the fixed private ip address to cisco port LAN belonging to my private network, then to c...

how i can move the database from a CW2k (ANI Server) y put that database in a new instalation of CW2K???

I'd like to transfer my LMS database(CD 1 Rev. 5) from one Solaris 2.8 system to another in the event our primary server goes down. The backup server will essesntially be identical to the primary, and once the primary is down it'll even have the sam...

Hi,Abou this advisory:http://www.cisco.com/warp/public/707/cisco-sa-20030709-swtcp.shtmlIs the Catalyst 6500 (CatOS 6.3(3) affected for this vulnerability ?regards.

Hi,I have the config as below:access-list 10 permit 172.17.1.0 0.0.0.255route-map Test permit 10 match ip address 10 set ip next-hop 192.168.1.1 172.16.1.1 I need to send the traffic from 172.17.1.0 thru 192.168.1.1 interface. Incase it fai...