I have a few queries regarding Cisco QPM. These are- Does QPM support creating service classes (gold, silver,bronze etc.) based on Users rather than application.?- Does QPM provide APIs for integrating it with other systems (e.g. Order Management por...
I cannot access MSFC even in ROMmon. I´ve looked at the "http://www.cisco.com/warp/public/473/124.html" document. It states that if this happens then power off & physically remove the MSFC's bootflash. I´ve done this but still cannot access the MSFC'...
I want to telnet my switch 2900 series but the problem is that i don't the IP address of that how to find IP of the switch ..Please advice on it..RegardsShamsheer
Can this be done? I have a remote router, R5 that has its FE configured with 4 sub interfaces. R5 connects to my core router through an ATM interface. From the core router I have a FE interface into a 6509 Cat switch. The 6509 FE that connects wi...
A client Location A connects to Location B through a VPN connection.For restricted access to the client, there are access-lists(port wise) on a L3 Switch at location B.Some users at Location B connect to the client servers at location A (ie thru VPN)...
My customer wants to deploy 3600 routers at a number of locations, with async and X21 connection to x25 networks. They want to use XOT to transport between the 3600s. There will be 7206 routers at the core, which will route between the 360's, and ...
Can I remove all default views and use only custom/private views, so a specific user can see only a group of devices?And why when I restore from backup all custom views are lost.Thanks.
First two 3500 were HS , problem with autotest (C3500xl POST FAILURE: CPU Notify RAM Test: Failed) in the same bay.We also have a 3508 and is ok , We replace the 3500 with one 2950 and he was out with the message :PLATFORM_CAT2950-3-SCHAN_OP_FAILURE:...
Hello All,We have Cat 6509 MLS with single sup engine on our campus Network which serves to 2500 users . We have currently approximately 20 Vlans on our Network. We are getting one more 6509 which will be installed in other Bldg , with a dis...
Hi there,Today I ran the RME function "export to file" and upon examining the output, found the following error message:"ASA error -141: Table 'proxy_device_system_info' not found"A few minutes later I was using Device Center on a different device an...
Cat6509: Miirroring 2 source ports 6/42 and 6/43 to 1 VSPAN dest port 6/33.--------------------------------------------------1. All ports are 100bFull, all ports VLAN is 99, No TRUNKING on ANY port2. Host on port 6/42 and 6/43 explictly sending VLAN-...
Hii have stack of cat 3550 switches with GIBIC STACK module, i have many Vlans distributed on this stack, do i have to configure Gigastack port with trunk ? thx
Hi,I have a situation where in a customer has WIC2A/S port on the routers - 1700 series. The requirement is such that I have to use these ports as ISDN BRI dialback up , as there are no spare slots for BRI ports. Can anyone help me how to achieve thi...
Hi All,I am testing Checkpoint Firewall NG FP3 on SecurePlatform.My routers (1600's,2500's, 2600's, and 4700) are connected to a 2950T-24 switch, each on separate vlans.I connect to this switch with my new firewall via a 802.1q trunk. The "real" inte...
