Other Network Architecture Subjects

I'm looking at getting a VPN over Internet to Sweden from Tokyo soon. For backup purposes we will have dial on demand ISDN on Cisco 2600 series router.Can I configure HSRP or on the dialer to not dial during certain hours to save money? It's pretty u...

We had an isolated network (10.1.x.x-10.5.x.x) in a remote location for a period of time. Over the last year we installed a T-1 that provides us (our main office (192.168.x.x)) connectivity to that isolated site. The setup was configured as follows...

Recently we recieved a VIP6-80 . The minimum recommended IOS is 12.2T.This release does NOT exist on the related IOS planner.Please advise.Shlomo

Haloo networkers,Is it posible to configure a priority based on a single host? Lets say a host with IP 10.0.0.1/24 will have high priority when travel the WAN link compared with others user in the same network? Give some sample link/config please. I ...

I need multicast in just 1 VLAN (PC ghost with Symantec)I have configured a C2611 as IGMP Querier (ip multicast routing + ip pim dense mode on 1 interface)The router receive all the multicast traffic from the Multicast server andthe processor goes to...

Hi all,I have a very basic question, is that in TCP/IP, a segment is seperated to more than one packet, and a packet is seperated to more that one frame. But how the seperated frame be back to a whole packet and the seperated packed be back to a whol...

Is there any type of configuration for a 7206 to SPAN or monitor traffic? I am running mutiple 7206 with inbound DS3 and outbound VXR (SVC/PVC)connections to other sites (i.e traffic never leaves the router). How could I implement a spanning feature ...

I'm in the process of moving all VLAN's off of my 3524's to my inhouse 6509. Does anyone know of a diagram or tool that I can use to draw out my port assignments...so that I can look at what I'm doing before I make changes?Or...if there are any sugge...

In my CW show 5.4 (Build 41) in CiscoWorks 2000. Is this the lates ver? if it is not where can I find the newest CV ver for CW2000 Rev5.

If I create a VLAN on a subinterface and assign it to a bridge group:!interface FastEthernet1/0/7.1description Line 5 PLC subnetencapsulation isl 2ip address 172.17.71.128 255.255.255.0no ip redirectsbridge-group 1bridge-group 1 spanning-disabled!and...

We are a telco and ISP offering DSL service to our customers, and currently have an OC-3 link from our Cisco 7200 to our ATM switch that aggregates the traffic. We currently have a vpdn group set up to accept the incoming connections, but I have som...

Can ciscoworks 2000 check throuhput/Statistics on ports onswitches and routers? Can it do trending as far as utilization on a specific port or router interface?

Is it possible to have mirror traffic that has been received/sent for more than one VLAN on more than one source port and/or destination port on the same switch for 5500 v5.5.5 and on 6509 Native IOS?Also, I believe you can SPAN a trunk, but can you ...

HeiI used to have ip address from my ISP through Cisco Switch , and Now When I connect my LAN With a Cisco 3620 Router , I could not get ip address from ISP to my LAN.I have configures ext. FE with ip address dhcp , I have configured my router to be...