Is there a general guideline as to when it is best to use route-maps versus filter-lists versus prefix-lists for inbound or outbound BGP filtering? What are the advantages/disadvantages of one method over another?
Is there a general guideline as to when it is best to use route-maps versus filter-lists versus prefix-lists for inbound or outbound BGP filtering? What are the advantages/disadvantages of one method over another?
Here is the sceneiro:PC --- 827 --- DSLAM --- 3660If the 3660 serves as the ip pool, the PC can initialize a PPPoE session to it and get an ip address, using the command 'peer default ip pool pool-name'. However, if the 3660 was configured to direct ...
I have an AS5400 I am trying to determine at what speed they are getting connected. What command provides this? The problem we are having is a user is able to connect fine from one location then when they take their laptop home it doesn't work. An...
Network Node Manager 6.2 running with HP-UX does not define and show a router as a router and shows that a generic device. We checked Object Properties and saw that NNM discovers that device as a computer not a router.The other device which has exact...
Hi.I have 2 Cisco 3640 (Cisco1 & Cisco2) connected to a firewall (static routing) and behind it there is a DMZ. A group of customers are connected to Cisco1 and other group is connected to Cisco2. In case that Cisco 1 goes down , how can I change the...
I'm wondering when (if) Gateway Load-Balancing Protocol will become a standard in IOS? What platforms is it currently supported on (if any) and in what IOS versions? Are there plans to implement it on all platforms?Finally, is there currently any...
I have a 2611 with IOS 12.2.7, 16 MB of flash and 48 Mb of DRAM.Triple-des IPSEC configured on an ISDN link.It appears that if a reload command is issued on the 2611 across the encrypted or unencrypted isdn link the 2611 fails to reboot.This also occ...
when i add a device in rme and give the snmp community rw, it's give me an authentication failure message at the first device attribute checks, even if the community is right. I try todelete the entire database and re-insert the object but nothing ch...
Hi,Just looking for any advice or recommendations on deploying CatOS or Native IOS on future Switched Networks, either at the Core or Distribution layers.Thanks in advanceSean Murphy
Hi All,we have a lease line connectivity between head office and branch officeTraffice flow across the link comprises of voice and data.However since there are two links of 64Kbps between both the office , We would like to load balance the traffic be...
what is the difference between IPv6 and IPv4?
how to establish layer 2 and layer 3 fail-over (redundancy) for Campus network.5000 users and multi-location+multi building+multi floors.Looking for suitable products and design.
Is it possible to use a NAT pool to translate, say first 10 hosts inside and have the 11th hosts and onwards use PAT? I know this can be done on a pix where PAT is used as overflow translation when you run out of addresses in your NAT pool. How can ...
Has anybody out there got any advice or comments on the exam? I have done the CWFUN and CWLAW courses but there is still some stuff that is in the exam that was not covered by the 2 courses. Any ideas where I can find this info?Thanks.
Hi,There are two routers (A & B). Router A has an ethernet and a token ring interfaces. Router B has only an ethernet interface. To configure DLSW, I have to configure SR translation bridge on router A as below:source-bridge ring-group 100source-b...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
07-17-2024 06:07 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |