Hi !Can anyone give me a very simple ATM example of "running" configuration for two directly connected routers (without ATM Switch in the midle) ?Woud be very appreciated for this.Regards,Bahrom
Hi !Can anyone give me a very simple ATM example of "running" configuration for two directly connected routers (without ATM Switch in the midle) ?Woud be very appreciated for this.Regards,Bahrom
Hi,What is the connection between ISIS routing protocol and CLNS? Do I have to enable clns routing to use ISIS? Thanks
Hi,I have an ADSL model connected to the Internet. I also have a Cisco 2514 router that I would like to connect to the ADSL modem to provide Internet to the internal network.I erased the startup-config on the 2514 so as to configure it from scratch...
Hello, Are there any MIB variables that contain the information of the 'show isdn service' CLI command for an ISDN PRI? Thanks
Hican any one tell me how to find a IP address of a windows machine/network device using its MAC addressthanks in advanceGanesh
I have a 3640 and when power cycled it fails to boot due to illegal DRAM. The router comes up in rommon. What can I do to save this router???ThanksM.
Hi,I'm new in network monitoring.Is there a good whitepaper or link which deal with logging level, facility...Some tips about what level to log, how to organize multiple router monitoring with Syslog.I know that it will be better to implement an SNMP...
Hi,Can set Alarms on Jitter/Packetloss/Delay with RMON,if yes how do I configure it (what objects)?Regards,Sascha Monteiro
Hi, I am trying to configure Cisco Pix Firewall 515E. Can anyone let me know, which book I can buy for reference and studying about the PIX Firewall Technology.Thanks,Amit Sonik
Is the 7200VXR the same as the Ubr7200?
is it possible to break/change the enable passowrd of a cat6509 without reloading the switch. we have forgotten the passwordcurrently we have the 1st level password.
We are facing a strange problem here. We have 6548 module in cat6513 switch running over CatOS 6.3.1. It was working normal but recently we lost any traffic going into or coming out of this module. Has anybody faced this problem ?
I have a scenario I am trying to get an explanation to regarding 2 PIM DR's running as anycast RP's attached to a LAN. Basically I cannot understand how PIM,IGMP operates in the scenario below with the respect to the forwarding of source traffic fro...
Can someone give me a helping hand?I am using cisco 2620 routers (provisioning: 2x Smart Serial / 1x Ethernet / 16 MB Flash and default RAM)in a pure DCN (means: only clnp traffic)environment. All routers are running IS-IS. The network is separated i...
I was successful setting the eth. int. to full duplex on the 3640 by upgrading the IOS to 12.2, but can I do the same on the AS5200? They don't publish an 12.2 ios for the 5200. Will it do full duplex with 12.1? Can I do full duplex through the ether...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM | ||
11-10-2023 09:28 AM |