Hi,I'm new in network monitoring.Is there a good whitepaper or link which deal with logging level, facility...Some tips about what level to log, how to organize multiple router monitoring with Syslog.I know that it will be better to implement an SNMP...
Hi, I am trying to configure Cisco Pix Firewall 515E. Can anyone let me know, which book I can buy for reference and studying about the PIX Firewall Technology.Thanks,Amit Sonik
is it possible to break/change the enable passowrd of a cat6509 without reloading the switch. we have forgotten the passwordcurrently we have the 1st level password.
We are facing a strange problem here. We have 6548 module in cat6513 switch running over CatOS 6.3.1. It was working normal but recently we lost any traffic going into or coming out of this module. Has anybody faced this problem ?
I have a scenario I am trying to get an explanation to regarding 2 PIM DR's running as anycast RP's attached to a LAN. Basically I cannot understand how PIM,IGMP operates in the scenario below with the respect to the forwarding of source traffic fro...
Can someone give me a helping hand?I am using cisco 2620 routers (provisioning: 2x Smart Serial / 1x Ethernet / 16 MB Flash and default RAM)in a pure DCN (means: only clnp traffic)environment. All routers are running IS-IS. The network is separated i...
I was successful setting the eth. int. to full duplex on the 3640 by upgrading the IOS to 12.2, but can I do the same on the AS5200? They don't publish an 12.2 ios for the 5200. Will it do full duplex with 12.1? Can I do full duplex through the ether...
In one city I have a 1700 (A) that connects the LAN to a server and another 1700 (B) that routes to the internet. In a second city I have a 1700 (B) connecting thru a T1 to 1700 (A) but I can't get to the internet or see 1700 (B). What do I need t...
Hello,What are the best practises to solve this topologyI have several branch offices connected via BGPto a BGP core Network. Branch office X use 10.X.0.0/16 networkI would like that network core announces summarize10.0.0.0/8 to each branch offices.E...
Hello, I use cisco's DialOut utility using 2 AS5300's. I'm trying to figure out a way to set up failover redundancy. Since the DialOUT client only allows you to specify one IP address of hostname of the As5300, I do not know how to set up failover to...
