Hi,appreciate some advice on the following:what is the benefit of setting arp aging time on router and mac address aging time on switches close to each other?Thanks,Christina
Hi,appreciate some advice on the following:what is the benefit of setting arp aging time on router and mac address aging time on switches close to each other?Thanks,Christina
Hello, I have problem in 2950 Switch, i configured a IP address on it, but when i try ping or telnet this switch, switch does not respond to my telnet and ping.But when i check a SH CDP NEIG command on a connected switch, Switch display the swi...
I have added a few access-lists to 7204 router with IOS 12.3. When I do "show access-list", there is no "matches" showing for new access-lists. Only change I have made was to enable netflow a few weeks ago. Previous access-lists are still working ( a...
I know that we have to put the "media-type rj45" command on interface 5/2 to make it work for UTP. Is there anything else that I need to do. I cannot get this UTP port to work. May be I have a dead port. I may have to replace the whole SUP720 module,...
If one wants to change the SUP720 module on a CAT6500, then how is the VLAN DATABASE trasnfered from original to new module. For startup config one can tftp the config from old module and then tftp back the same into new module. How about vlan databa...
All,I just wanted to get some input. I just recently started here at a site and I am unable to access the the user switch via ssh and telnet. Due to limited access to the switches to be able to create a raidus or local login what possibly can be th...
What is the command to reset a single line card on a 4506 switch?
Hi, I've been having this question for quite a few days, but can't get the satisfying answer. I have a device that connect to a Catalyst 4006. the switch shows connected. However, when doing a show port command, there is no mac under " Last-Src-Addr"...
I have L2 switch connected to my 20 system & my L2 switch is connected to L3 switch?My Q is what is the command to chk the traffic in L2 switch for each port& chk the log?thanks
I have a core of 2 x 6509's running HSRP between them, connected via a dot1q Ether Channel link with no VLAN pruning. Hanging off this core I have a 3rd 6509, this 3rd device is conected with two links, int 1/1 and 1/2.6509 #3 is configured as such:s...
Hi,Is there any lmitiation for install WS-X4418-GB on WS-C4006 Switch? How many can be installed?Thanks.
Can someone tell me if the FWSM is supported in a Catalyst 6513 running the Sup32 and MSFC2A - hybrid mode.Thanks
%PM-4-ERR_DISABLE: loopback error detected on
I have been working with access lists for a while now and i think i have a good knowledge about them. But the thing i'm still confused with is when you apply ACL "in" and "out" to a SVI or lvna virtual interface.It seems like in these type of interfa...
hello, pls i would like to know if the cisco2960TC-24port is a layer 3 switch.thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM | ||
11-10-2023 09:28 AM | ||
11-09-2023 09:30 AM | ||
11-08-2023 03:38 AM |