Other Network Architecture Subjects

If one wants to change the SUP720 module on a CAT6500, then how is the VLAN DATABASE trasnfered from original to new module. For startup config one can tftp the config from old module and then tftp back the same into new module. How about vlan databa...

All,I just wanted to get some input. I just recently started here at a site and I am unable to access the the user switch via ssh and telnet. Due to limited access to the switches to be able to create a raidus or local login what possibly can be th...

What is the command to reset a single line card on a 4506 switch?

Hi, I've been having this question for quite a few days, but can't get the satisfying answer. I have a device that connect to a Catalyst 4006. the switch shows connected. However, when doing a show port command, there is no mac under " Last-Src-Addr"...

I have L2 switch connected to my 20 system & my L2 switch is connected to L3 switch?My Q is what is the command to chk the traffic in L2 switch for each port& chk the log?thanks

I have a core of 2 x 6509's running HSRP between them, connected via a dot1q Ether Channel link with no VLAN pruning. Hanging off this core I have a 3rd 6509, this 3rd device is conected with two links, int 1/1 and 1/2.6509 #3 is configured as such:s...

Hi,Is there any lmitiation for install WS-X4418-GB on WS-C4006 Switch? How many can be installed?Thanks.

Can someone tell me if the FWSM is supported in a Catalyst 6513 running the Sup32 and MSFC2A - hybrid mode.Thanks

%PM-4-ERR_DISABLE: loopback error detected on

I have been working with access lists for a while now and i think i have a good knowledge about them. But the thing i'm still confused with is when you apply ACL "in" and "out" to a SVI or lvna virtual interface.It seems like in these type of interfa...

hello, pls i would like to know if the cisco2960TC-24port is a layer 3 switch.thanks

blr1-corp-swa#sh clock*01:41:50.897 PDT Sat May 22 1993blr1-corp-swa#where as updating on the other switch with the same configblr1-corp-swd#sh clock.02:51:28.863 PDT Thu Jul 20 2006blr1-corp-swd#

if I set this to 0, does this mean dont drop the line ?