Other Network Architecture Subjects

hello,,,"mc3810-a2jsv5-mz.120-7.XK2" i want to know how each and every letter of this image name will be interpreted...similarly i want to know for all other ios so please send me some good link regarding to naming....regardsDevang

Hi all, I am still having issues with redistribution, if im redistribting eigrp into ospf what metric values do I need to put in ? do I need to work them out and if so how to I do this ?thanks a million

hello,,,3810#clear interface serial 0 what this command will do?regardsDevang

Hello,I would like to define a SPAN session and output traffic to multiple destination ports. I am running into limitations on the Catalyst 2950 and 3550 switches of only being able to define one or two destination ports for this traffic - in most c...

IOS: 12.0(5.3)WC(1)Looking for the syntax to rate limit a physical FE port to one meg. Not looking for a custom queue, just a hard top limit.

I'm installing a stack of 3x 3750G switches, which are inter-connected w/ StackWise cables.Are stacked switches truely act as one switch w/o any performance penalty if a packet has to traverse from one switch to another in the same stack?Would it be ...

We're trying to install a new Wathguard Firebox Edge and when we replace our old Firebox SOHO, and login to the 1602R, "show arp" has question marks on the MAC address next to the IP of the Edge firewall. We've tried rebooting the router and running ...

Just not sure how to do this, But I need to allow 5 or so connections in this network. I'm using DHCP on my outside interface. I thought of use ip nat outside; but I don't seem to be able to use the FastEthernet0/0 as ip source. Anyone have an idea?

I saw that the 2960 can support up to 256 multicast addresses, while performing IGMP snooping. Is that per interface or per the whole machine ?Thanks.

I have a few routers (2621s and 1811's) connected to two different ISP's. Both ISP's give me ethernet interfaces to their service. One is a Fibre Optic Link and the other is several ASDL lines. On each of the routers I have configured NAT and stati...