Other Network Architecture Subjects

HelloI need login to router via console directly to enable mode using local authenticationwith commandsaaa new modelusername test privilege 15 password testaaa authentication login console localline con 0login authentication consoleIam NOT in enable ...

HiBrand new 3825 with c3825-advipservicesk9-mz.124-3c.bin IOSInstalled NME-XD-24ES-1S-P moduleRouter does not see module, module has flashing green SYST and flashing amber STAT LED's.So, dead module or am I missing something?

Hi, I have a question regarding STP calculation triggers in ISIS.What triggers SPF (re)calculation in Level1/Level2 in ISIS?David

Hhave a look to this scenario: L3 SW1---------------SW2 ACCESS SWITCH LINK TOWARD--------SW1 TOWARD--------SW2ACCESS SWITCH CONNECTED TO EACH DISTR.I NEED TO IMPLEMENT GLBP FOR GATEWAY LOAD BALENCY.I NEED THE CONFIGURAT...

i have a new 2950 switch, when i connect it through trunk port , and try to telnet it or ping it give me no response put port i up, "show cdp neighbour detail" command is also mentioned the ip of that switch and connectivity..

Can anyone tell me the main differences in these 2 ?

Hi AllCan someone take a look at this PDF:http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/cdccont_0900aecd801a8a2d.pdfOn page 40, figure 41 - with VLAN 2 present on two access layer switches, and both switches uplinked to the two c...

Hello all,I'm looking for a switch port monitor capable. 8 or 16 port 10/100. What I really need is the port monitor.I want a cheap one, and I've looked for in the linksys series. Which switch is as I'm looking for? Which one do you recommend me?Than...

Just to make sure that i can use ONE CD-3560G-EMI upgrade for more than one Cisco 3560G switches with Standard images?Thanks in advanceAbd Alqader

HITHIS IOS:flash:/c3560-advipservicesk9-mz.122-25.SEE.bin".SUPPORT GLBP10XS

Hi,I need to setup port mirroring on Catalyst 4006 switch. Both source and destination port is on the same switch.I need to capture all traffics across the LAN for analysis. Is it enough by configuring SPAN? Please advise.

Can somebody from Cisco in here confirm/deny rumors about EOE for CatOS withint next 12 months?