Other Security Subjects

Hi I have a dmvpn hub setup with several spokes attached.I run eigrp between hub and spoke and inject a default route to the hubs so all traffic is routed via the tunnel interface on the spokes.I need to enable internet access for a customer over the...

Is it possible to collect ARP information from a FWSM v 3.1(1) routed context using SNMP ?Thanks

I'm interesting what limitation on number of ACL strings does cisco catalyst switches have, in particular 3750?

I have a 6503 switch, and am 10.200.251.3. I am between two cisco routers 1.200.251.1 and 10.200.251.2. My SNMP host is on the .2 side. His addre is 10.200.10.10. Should i need a static route such asip route 10.200.251.2 255.255.255.0 10.200.251.2...

I have a 1811 using NAT to get our internal services out to theinternet. I have 2 dns servers on the inside of our network that servepublic queries.I have a class c (provided by my ISP) for my outside interface. I havethe last 11 addresses setup in...

Hi. I have a newbie question. I am trying to add a Cisco 3005 Concentrator to CSM and I keep getting a very vague error ("An internal failure has occurred. The cause is unknown"). I am trying to add it by going to "file", "new device" (in the device ...

I am facing a problem in pix515e 6.3(4) in failover mode. Problem is that when I make secondary as active firewall traffic is running fine but when I am making primary as active traffic is not smooth and there are RTOs after 10-15 replies. Again if I...

Can someone tell me the advantages of having all network devices in the MARS configuration. Do the layer 2 access switches provide any relevant information?

We're running a MARS 100E and have created a seed file to mass import 120 IOS routers. The seed works great and imports the devices but then we must go through each device and discover it. This is needed to discover the interfaces and attached netw...

Hi,Is anyone successfully using Lotus iNotes and WebVPN ? We are using Domino 7 through a VPN Concentrator running 4.7.2.F. When we try to access any messages in iNotes we see the following Domino error. "Domino Web Access Warning. Sorry, we are ...

Hello, i am not a good Pix user, i need to create a new Network on a same physical interface, according to me i need to move my physical configuration to a virtual and let the physical with no ip address, i'm looking for the easisest way to do it wit...

The example rule in the manual states this:The following ACL permits ICMP echo-reply messages into the inside interface. You must allow all other traffic with the last rule. This ACL permits hots on the inside to ping hosts on other remote network...

if the fwsm log can record the which web site accessed by user?how to see it?thank you very much.