Cisco’s security team has released an advisory for: RV340 Series Small Business routers (PSIRT Notice) Fix for bug CSCwc53007- RV34x GUI not accessible – The recommended fix is to upgrade to firmware version 1.0.03.29RV082, RV042, RV016 (PSIRT Noti...
Forum Posts
Hello! This sticky-post will serve as a sign-post for incoming community members. Below you will find links to pages that you may find helpful. Virtual Assistant - Discover support content and options for your gearSupport page index - Contains a...
Resolved! RV345P-K9-NA V02 latest VID?
Is V02 the latest version (VID) of this router? This is the PoE version. If not, can I exchange it with Cisco for the latest revision?
Hi, we recently purchased a RV340 dual WAN router.In order to check the status we need to collect data using SNMP.After the first setup we was able to get data from SNMP, except for Interfaces (the only data that we need to collect...).After upgradin...
Hi, I am trying to connect a RV260P router to the WAN using for the DHCP requests a resolver using DoT or DoH encryption for the DNS requests. Entering the static DNS to the appropriate resolver the internet connection for new requests does not work ...
Efetuei uma configuração Ipsec VPN Server no RV130W e configurei uma conexão cliente consegui efetuar o tunel porem não tenho acesso ao IP do roteador não estou conseguindo enxergar nenhum IP da rede conectada no RV130W alguem me sabe dizer o que dev...
I need to port forward 2 CCTV servers, I have set the Services up and only 1 (.150) works. Below are screen shots of the config. When I try to set the 2nd (.120) to WAN1 the window goes red and will not save. Its probably something simple but I can't...
Hi,I have a RV320 here on a 500/500Mbit fiber line, and don't seem to get more than ~230Mbit througput.If I connect the original modem from the provider, I get 500/500Mbit throughput.Firewall is off while testing.Does the RV320 not provide more throu...
Hi I have three sites connected with RV routers.Site A 192.168.2.0/24 with router RV132W is connected with site to site VPN to site BSite B 192.168.0.0/24 with router RV160 is connected with site to site VPN to site A and CSite C 192.168.1.0/24 with ...
Hello, On my RV345 I am getting daily errors below about the webfilter. I have tried toggling it off and on which resolved for a short while but the error came back so I am not sure what is causing the failure. I have allowed connections to brightc...
Hello,I have the log configured on the RV345 router to send me email alerts with a severity of error and higher. A few times a day I get an alert with the following: <error>dnsmasq: failed to allocate -1 bytes<error>dnsmasq: failed to parse lease da...
I have CenturyLink gigabit fiber at my business and have requested and received a static IP address for site-to-site VPN use. I am using a Cisco RV340 router and it has been working perfectly with dynamic IP. I don't use any sort of Centurylink provi...
Resolved! RV340 behind NAT/Firewall router
Hi We bought two RV340(W) to create a site-to-site VPN, eventually. But for now, we have basic configuration problems.Both RV340 will be behind routers with active NAT/firewalls/DHCP. VPN-Router 1 will be in local network 1 with local IP addresses 10...
Hello, I have a RV345 small business router. I use the Shields Up service from GRC.com to test my router against incoming ports. This service scans ports 0 thru 1055. Under normal circumstances, all ports should show stealth as I do not do any kin...
Resolved! C1116-4P Metered Routes
Hello Everyone, I'm looking at getting the C1116-4P for a branch office. This office will have a layer 2 point to point connection provided by the ISP back to the HQ. One of the ideas being entertained as well is to have a separate Internet co...
Resolved! RV042G bottlenecking on 250MB service.
I have RV042G with firmware v4.2.2.08 (Apr 26 2013 19:12:26). We recently had our ISP remove the 8x T1 service and install a 250MB fiber service. After the installation, when directly connected to their equipment, a speedtest is ran and 250MB speeds...
Hi all,I'm trying to setup an openVPN server on a rV320 router. but the Certificate generator doesn't seem to work.I can generate a self signed certificate without a problem but when i try to enable the openVPN server I cant select it in the "Root Ce...
