Routing

Yesterday I had to configure a Cisco 891F router as an internet access router with PPP authentication. Behind this router, a firewall will do NAT and routing.   After configuring the PPP on a dialer interface I receive an IP-address, subnetmask and d...

hi guys i have an isr 4331 router and i want to do static nat or port forwarding on this router but when i use this command: ip nat inside source static tcp 10.10.10.1 554 interface gig 0/0/1 554  i get a err which says the port 554 is being used by ...

Hi all, I've pretty much sorted all of my main issues configuring Multicast Helper-Maps but there is one thing I'm having issues with. I'm using the following config: ACL: ip access-list extended CISCO3000   permit udp any host 10.1.1.255 eq 3000 ip ...

Hello, I need to configure an ACL to deny telnet from any host on subnet 135.79.40.0/24 to anything on other subnets.   I think I want to do something like this:access-list 150 deny tcp host 135.79.40.0 0.0.0.255 any eq telnetBut I am not getting any...

I have a Cisco 1700 and was wondering it is was possible to configure as a T1 Pass Through?  The customer is getting a T1 as a backup to our fiber- required by German corporate.  They however, don't want to buy a different Router and want to still us...

Hi Team, I am planning to terminate 250 Mbps ILL 1:1 in cisco 2951 series router please confirm whether this router will support maximum throughput of 250 Mbps link. If yes will it support download 250 Mbps + upload 250 Mbps simultaneously. Please he...

Hello All, I am facing high cpu utilization on my cisco wan qos router. I shared the load by 50:50 with another wan qos. But in frequent intervals, it showing 90 to 95 % CPU utilization. Attached the sh run, sh ver, sh proc cpu outputs. Please help

Hi Guys,   We currently have 7 sites and adding a new one. My query is regarding prefix lists. As far as i know prefix list controls what is advertised. If no prefix lists are applied and neighbor is advertised will all the routes be advertised autom...

Hi everyone, thank you for taking the time to read this.   After moving to a new site, we realized that our speeds were 200 Mbps instead of the promised 300Mbps.The ISP was seeing 300Mbps on the circuit and asked to test.   At the Handoff I get 300Mb...

Hallo,Do you anybody know how to disable/turn off "Checking for product update" during _every_ connecting Cisco Anyconnect Secure Mobility Client (VPN) to remote sites?I found it may by possible on the ASA side, but I need to disable it on the client...

Hi Everybody,   I have a NAT issue with a ISR 4331 with a working configuration from a 2911 router. When a VPN client tries to connect to 10.226.26.1 port 443 there is not translation to 10.220.202.24. There are matches in VPN_ACL but the VPN client ...