Routing

Hi, i have asked to configure port forwarding to access the remote access server from the internet. i have not done this before. we have ADSL router from the ISP and  a cisco router. where should i configure port forwarding?Thanks

Hi All, I am working on 2951 ISR Router. This device has booting issue, when switched on its displays the following message: System Bootstrap, Version 15.0(lr)  M16, RELEASE SOFTWARE (fcl) Technical Support: http://www.cisco.com/techsupport Copyrig...

Has the command "bridge protocol ieee" been deprecated?  And if so what do i use to create the bridge groups?

Hello friends,I have a problem; now i'm changing the router that have at work of Cisco 3925 to Cisco ISR 4451X but in the new router i can't put the command that have in my old router:rate-limit input access-group 110 16384000 3072000 6144000 conform...

Greeting I am configuring aaa privilege I found that more command is adding automatically. I can not remove this command and If I successfully remove it ; it remove main command also . I configure the below command ; privilege interface level 4 shu...

Has anyone any idea what this means?I have found this http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_system_message_guide_chapter09186a008009e7a4.htmlthat tries to explain the problem and how to fix it, but I'm apparently stupid beca...

Hi In router configured with ospf, if we set up debug ip packet, we will see a lot ospf multicast message, which interferes with what we want to see. So if we want to see debug ip packet clearly, we can set up acl to filter ospf multicast message. In...

I have a ISR 4451 router with a SM-X-6X1G module with only one port on the 6X-1G module in use (using a GLC-GE-100FX SFP) currently.  Even though I have configured the interface with the Media-type SFP command, every time I reload the router this int...

I hope anyone can assist. I am trying to set up a secondary MPLS router at a secondary data center. Currently the primary MPLS router at the primary site injects a default route into the remote MPLS routers via default originate under its bgp procces...

Hi, I have a used Cisco ASR and I cannot get into the switch. It looks to me that it either has a local username and password OR the configuration had TACACS on it. I would like to know since its a now an offline, non-production router;  if it had ...

Hello Geniuses... this is my 1st question in the Cisco world and i m very glad to discuss my queries with world best geeks. I have a task to merge/combine bandwidth of multiple Radio (Rocket M5) with Cisco Switch, basically we need total throughput o...