Hello, We have an ISR4321 router and currently using the two onboard RJ-45 Copper ports. There is an SFP port that's currently not being used. We need to use third third SFP port; however, the specs in the datasheet(see below and scroll down to ISR43...
Hello,i am new in iosxr and i have to handle some tv streams from TV studios that are directly connected to my cisco NCS57C3mod. Each stream with specific (different) multicast address is connected in separate vlan. For eg 10 streams are connected as...
Hi there - I've inherited a Cisco 887VA router and have successfully factory reset it to 10.10.10.1. I can browse to it, using the default cisco/cisco credentials, but there seems to be no GUI - only a list of commands. Does such a GUI exist, or is t...
Does the C-SM-16P4M2X support 100M? Couldn't find any pages about this module.
Hi Guyshoping someone can clarify as there is multiple different answers out there.As we know, by default an interface only has a hardware queue which is FIFO.When we create a qos policy with CBWFQ / LLQ etc, this then creates software queues which t...
HelloPlease bear with me while trying to explain my problem.I am currently unable to get a route pushed to AnyConnect clients, even if it's visible in the split-tunneling ACL with the internal LAN networks that gets pushed correctly. My question is w...
I am trying to block all outgoing multicast streams on my edge switch nexus 3k. The port is connected to a remote location and is a trunk port. I have devices receiving video streams inside my network through this port and I need to keep it working, ...
Greetings.I recently got my hands on a Cisco 800, quite old but reliable device, but there are a number of problems during configuration.I have successfully configured internet on FE4 (WAN), ping to 8.8.8.8.8 is fine, internet through another LAN beh...
Here is my topology in gns3: I plan to form a tunnel between R3 and R4, and the loopback and tunnel interface is as shown next to the routers. I've set the tunnel source and destination for both routers with the loopback interfaces, and all physical...
Hi guy,I am searching for ISR4000 Series ( ISR4321/K9 ) does it support GLBP ( Gateway Load Balancing Protocol ) feature? And does it need license to use?I searched many websites and found no information.Please help me to findout.Thank alot!
Hi AllWe would like to capture netflow from traffic that flows via our dmz switches that connect our internet routers. the switches are 9300's.Is it possible to capture L3 traffic going through them without a routed interface?Many thanks
Need some help with 9300 Static Routing. We have a stacked 9300 being used as a collasped core with all of our VLANS on it. Each VLAN has an SVI and IP routing is enabled. We also have a gateway of last resort set of the firewall that is connected...
Hi,We have Cisco ASA 5515 installed within our office, I wish to ask is it possible that a route for LAN1 to ISP1 and LAN2 to ISP2 work at the same time as shown in above diagram ? Furthermore, an additional static route for both LAN1 & LAN2 towards...
My 9300 is unable to pull a license from the portal, I believe I have to configure it to be able to achieve this but I don't know what I would need to do. I currently only have 2 ports configured that go directly to the ISP what do I need to do to al...
