Routing

Hello everyone,I would like to configure route damping on two routers, each receiving Internet routing table from two separate eBGP neighbors.We are a Cloud service provider, so obviously route stability matters and that's why we were thinking of imp...

Hello All, We have a 7200 router in my network which links two major sites . The problem we face is, the wan interface keeps throwing Output errors.This link is 300 MB link and only 15% usage is observed all the time. Fastswitching is enabled. interf...

hi expert, seeking your great advice on the below scenario:I work in small ISP and we provide internet over DSL and point to point internet as well.We have a cisco SCE in which we use to control customers bandwidth and monitoring. The thing we are fa...

Hello,I want to monitor my ISP modem, it is a Cisco EPC3010: http://www.cisco.com/c/dam/en/us/products/collateral/video/cable-modems-high-speed-data/7018339.pdfIn the documentation says that: Quote:Remote manageability using SNMP V1/V2 and V3I can ac...

hello,we have a ppp over atm link connected router with dialer 0 interface and virtual-access1 clone of it because of ppp connection.You can see the configuration below;interface Dialer0 description VAE_DSL_primary ip address negotiated ip mtu 1300 e...

I am little new in data center and will have to exchange a core 3750 switches with new 4507 R+E switch.I have managed the license installation but i need little support when copying the config file. How to copy the running configuration to this new s...

Dear Team, Currently, I am doing the User Acceptance Testing for the Enterprise Network which includesASR 1000 Series, ASR 9000 Series, Nexus 7700 Series, Catalyst 4500 Switches. I am doing this testing for the first time. If any body has experience ...

I am trying to work on a DMVPN solution. It has abut 10 spokes and 3 Hubs. Hub1 and Hub2 are located in the same location(Say SIngapore). Hub-3 is located at a different location(say USA).I am trying to achieve failover between the 3 Hubs. All the 3 ...

I have a LAB scenario to discuss with you if you can assist me to figure it out the correct IPs to uses.Environment: Site A (LAN 1) ==> Connected with a Switch (Running MS Server 2012 R2)Site B (LAN 2) ==> Connected with a Switch. (Running MS Server ...

I am having an issue with connecting to the internet on my network.  From my ASA and Router, I can ping 8.8.8.8 but not from my switches.  On my switches I can ping all subinterfaces and the outgoing interface on the router.  From switches, I cannot ...

We had an issue at a Remote Site where tenants needed to connect to their corporate site using a VPN connection We have Meraki APs providing DHCP in the 10.0.0.0 subnet which overlapped with their network so I reconfigured the ASA with a "guest" VLAN...