Routing

We have 2 geographically diversified Internet connections with separate providers at 2 separate ends of our network.  The edge routers connecting to each internet providers are advertising all routes via BGP with preference given to the higher bandwi...

I have a cable circuit for a customer and a DSL conenction for failover.I have configured the router to track the default gateway and a DNS server out the primary via SLA ICMP reachability.I track the primary default route, which should be removed fr...

Hi,I will be setting up Full Tunnel SSL VPN using my asa 5520 as a vpn server.After reading documents I know that NAT must b disabled on ASA for the pool addresses.Can anyone explain te exact logic behind this.Regards.

Hi,I have a cisco 1801 with an ATM0 interface (WAN) and a FastEthernet0 (local lan). I am using latest 15 version of IOS. I habe tried hairpining using NVI and that works but NVI does not perform well so i want to go back and use plain old nat betwee...

 Hello All, I have inserted 2 SFP modules in 3925E ISR G2 router and need to connect fiber to it. I just want to confirm to make the SFP up and working do i need to configure any commands under the interface configuration to make the link up.  or tho...

I have pulled my hair out searching the internet to no avail.  I am attempting to setup multiple WAN IP's with my RV220W so that I can access the internal servers with those WAN IP's.  For some reason I cannot get the One-to-One NAT working correctly...

Dear friends I am new in ciso and I have configured inter vlan routing on Cisco 3750 but it does not working. The pcs can ping their respective gate ways but could not ping one another and I can also ping SIV port from all pcs but could not ping the ...

i have setup the port forwarding to internal LAN having 2 web paged http://server-ip/url1 and http://server-ip/url2 but on the same port no example port 8080and i want to allow the access of only one url i.e http://server-ip/url from outside the netw...

Hi Everyone.... I need urgent help on the below scenario....ISP Managed Router connected to ADSL & looked for me to view or change configuration.... i have successfully configured my own 2921 to work with ISP router with IP NAT, Internet is working f...

Hi Team, I would like to know what exactly is the difference between Sync/Async modules as compared to normal Async Module or may be the HWCI-4T kind of line cards. For eg: Difference b/w HWIC-4T and HWIC 4A-S, when exactly should i use HWIC-4T and w...

I am setting up AVC on our ISR G2 router and creating a flow monitor as followsflow monitor type mace FLOW_MONITOR_INPUTExporter xxx when i write record , it says unrecognized as followsxxxx(config-flow-monitor)#record ?% Unrecognized commandif i wri...