Routing

Hi, I've been looking through our VPN Tunnel Interfaces and noticed all of them have the same BW of 9Kbit. Where is this figure derived from? sh int tu17Tunnel17 is up, line protocol is up  Hardware is Tunnel  Description: Tunnel to M  Internet addre...

Hi,Need some help on the below. i have 3 internet links with different BW working in load balancing mode. i want to configure in such a way, the traffic should go to the link which has higher BW, if it reaches 80% then the second link should take the...

Here is the basic network info:6 remote sites with thin clients, VoIP phones, and some PC's1 Central officeDatabase hosted in cloud environmentThin clients at remote offices need to connect to central office via citrixPC's at remote offices connect t...

Hi guys,I'm seeing an error trying to ping from CPE to PE, although interface is up and configured:TNRTAGCS01057#ping 192.168.206.17Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.206.17, timeout is 2 seconds:.....Success rate...

Hello all,I have a very weird issue at the moment is a Cisco 887 DSL router running IOS Version 15.2(4)M6.The IP address of a LAN device appears in the router arp cache but does NOT appear in the switch mac-address-tableEven if you ping the end devic...

I am using Cisco packet tracer.I connected two routers using a crossover cable.My interface gigabitethernet0/0 is up while the line protocol is down (disabled) .I used the no shutdown option.I also changed the speed and the duplex to auto mode.Still ...

Hi All,We have recently purchased a Cisco 2951 + SM-ES3G-24 module. Bit confused when tried to configure it. Much appreciate if  some one can explain following points ? (1). Is GigabitEthernet 1/0 & 1/1 are Virtual ports or Switch module internally c...

Need to know what is the current maximum number of switches that can be deployed in a 3850X stack.

Hi everyone,I have a client with a Cisco 892 Integrated Services router, and two ISP lines. He would like to implement automatic failover in-case the primary ISP goes down. I lack familiarity with integrated services routers, but will a static defaul...

Hi All,i am planing to configure WAN redundancy using ospf in routers. Currently we are using only one router and planing to install second in live environment.Please  suggest about the configuration in Primary and secondary router for redundancy so ...

Hi,I am about to purchase a Cisco router 2921 ISR2. I read all the documentation about the installation of a fully featured licence but I dont't manage to find any mention about the price of that licence.So my question is : is that licence free or do...

Hello Cisco Community-I am hoping someone can assist me with this.  Working with a Cisco 1920 router (v15.2).  I am trying to map an inside address (10.11.8.226) to an outside address (162.x.x.83) so an internal web address can be accessed from the o...

how to configure netflow for ipv4 and ipv6 at a same time on router

Hi Everyone,I am recently noticing the error log below on our gateway BGP router and am interested to know the fix in order to clear this error log.Jul 22 11:26:47.739: %EARL_NETFLOW-SP-4-TCAM_THRLD: Netflow TCAM threshold exceeded, TCAM Utilization ...