Routing

We have a Cisco 7606-S with the following cards installed:7600-ES20-GE3CWS-X6724-SFPAren't both of the above cards 1 gigabit line cards?  What is the difference between the two cards?  Not sure why we have the two different cards installed. 

hi ,we use 3900 router,today morning when i come to know my default-gateway not able to response,then i connected to console ,i came to know which is in rommon mode ,when i check few command ,noting impact.in rommon mode i did use some commands plz c...

I am trying to figure out how to migrate from one ISP to another ISP using the ASA 5510.The first phase is to get outbound traffic to use the new ISP (faster) followed later by changing all of the NAT/Access Rules to the new DNS IP addresses.  I am n...

I have a dual stacked router for both ipv4 and ipv6. Ipv4 traffic should pass the zbf untouched due to the fact that there is another rock solid ipv4 firewall egress of the inside Interface. Is there a way that a class map like this could function on...

So If I were to have various type of line cards, (e.g. M1, M2, M1-XL, F1, and F2)what can be included in the same VDC?Can I mix M1 and F1 in the same VDC?I know F2 has to be in their own VDCs.What about the M1-XL line cards? Can I mix them in F1 and ...

Hi All, I have 2 separate FWs. One of them is the Gateway of last resort for the whole LAN.I have another FW with a different LAN side address and want to use this as the GW of Last Resort but only for a specific host on the Network.So when traffic c...

Hello. Does anyone know where to find Traffic Shaping info in 15.x? I no longer see the same info in the policy-map as you see in 12.4.x release. Below is a comparison of the same exact QoS policy configured on 12.4T clearly showing TS information in...

On the process of configuring QoS for Nexus I have come across both commands which "seem" to describe the same action. While looking into this further, it explains one can be used to mark traffic - but this can be achieved by both.http://www.cisco.co...

The above diagram shows the setup of my network.Router model : 2911 with ios 15.1 (both)R1 is my main router , all incoming and outgoing traffic will be handled by R1.As for R2, if and only if ISP A is down and unable to connect to the internet, then...

Hello,I'm currently studying for my CCNA and I was wondering if there was a used cheap gigabit router with IOS I should look for on the secondhand market. It'd be nice because I'd have to use the knowledge I have to set up my whole house. It only nee...

I am trying to bring up a MPLS connection between a Juniper MX960 and a Cisco 3750 through a Ethernet over Sonet connection.  We modified the configs so it is just a simple IP'd interface on both devices and we are continuing to get about 30%-50% pac...

Hi,I have a new EHWIC-4G-LTE-G module. The router is configured, signal strength is fine.Cellular interfaces are all down. Tried debug, got message:CHAT0/1/0: Chat script optus finished, status = Connection timed out; remote host not respondingCurren...

Hi all,Anyone know what could be causing these drops in the QFP:They are incrementing sh platform hardware qfp active statistics drop-------------------------------------------------------------------------Global Drop Stats                         Pa...