Routing

this is my config, trying to failover using WAN links between two sites , two c3750x one at each site. connected to Internet via Watcghuard XTM 505 devices and connected to each other for WAN -point to point link, that i want to use for failover.it d...

Hi, This is my 1st time setup dynamic routing. So please help me out.Attached is my diagram. Take a look.We have a new WAN connection. I setup the new WAN connection on my test router as the current connection is in production and use static route be...

Dear All, Can you tell me, is it possible to add one E1 / Module on 2811 Router. Will it support ? Is there any impact due to that? HQ#sh verCisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(17), RELEASE SOFTWARE (fc1)Techni...

I have a problem with HSRP routers becoming both active and rebooting on their own.The message occurring after the self reboot is the following:"Reload: Self Reload. Reason: Not in correct state for becoming standby."Is there any reason for this to h...

Hi, I am successfully using IP SLA and EEM for failover. I mean to say that i am monitoring one live public IP address with primary link. If that link goes down, the backup link must goes up by using Event Manager commands. But when my primary link g...

'evening,   Really basic setup.  Designed with Packet Tracer, trying to ping routers across a point-to-point frame-relay.  I've designed this according to three different training sources who all say the same thing.  Yet, all pings failed. The shows:...

The serial int that has a WIC-1DSU-T1v2 in my 2620 router says status is down down. The light in the back is AL - amber and CD - green. The interface also has the following status: DCD=down  DSR=up  DTR=up  RTS=up  CTS=downI had the isp test the conn...

Hi Team I have a case but i don't undersand clearly. I have a Router 7609 with SUP 720-BASE (Not 3B, 3C). But on it, we attached the 01 line card WS-6704-10G with DFC3BXL daughter card. I see datasheet and know that:SUP 720Base has maximum 256k route...

Hi,I want to know about IPSec (3DES/AES) throughput of Cisco 3945 / 3925 routers? I read about diffrent IPSec throughput values of Cisco 3900 series routers but there is no official site or document claiming about throughput. I got IPSec throughput i...

Hello, Is it recommended to use IGPs inside AS to establish relationship between iBGP peers or to use confederation / route reflect? What is recommended?Under what scenario the above choices vary? ThanksAftab

Dear ExpertI am using cisco 3845 at Head office  and 2801 at Branch with two WAN link over OSPF.my configuration as follows. Head Office interface Tunnel 1 ip address 172.24.26.1 255.255.255.252 ip ospf cost 500 tunnel source 172.16.1.1 tunnel destin...

Hi Guys,Im trying to minimise the problems caused when a neighbor flaps.Im trying to use dampening.I have the below config to dampen any route..ip prefix-list NETWORK_FLAPPING seq 5 permit 0.0.0.0/0 le 32route-map NETWORK_DAMPENING permit 10 match ip...