When upgrading a Cisco 2504 wireless controller to the release 7.4 software, is it necessary to also install the field upgrade software version 1.8? If so, does it matter which order these are performed?
HelloMy router 2811 have high cpu usage (80%)I haven't debug on my router.When I take show proc cpu, the list of processes total up to less then 10%I have lot of access-list (150) and 600 lines for it.I have policy map for ftp, visio, P2P, smtp, ...I...
I want to install PA-4T+-RF module on my Cisco 7201. I noticed that this PA is designed for Cisco 7204 VXR, but I wasn't sure if it was compatible with a Cisco 7201. The specs for the 7201 say that the Port Adapter PA-4T+ is compatible with a Cisco...
Hello everyone and thanks for reading! We have several locations all across the southeast. Our locations are joined by an MPLS/DMVPN network using different ISPs. Corporate has the company wide internet access, in other words, ALL INTERNET traffic co...
I have 2 - 3560X's running c3560e-universalk9-mz.152-1.E.bin. I want to have three different routing tables, STORE, ENDUSER, SERVER.My question is how to setup OSPF, do I create 1 OSPF instance with all of my subnets, or do I create an instance for e...
Hi All,I'm sure there are many threads on how to configure dual ISP's with Policy Based Routing & the issues involved with using a single ASA in this enviroment. But this won't be one of those threads. The network i'm about to discuss actually works ...
Guys,Need to change NAT for a specific VLAN to use the secondary IP address and not the primary IP. Please assist.Qns:1) I need to create a pool so as to nat to the two addresses, problem is that the addresses are not contiguos (like 10.10.10.10 and ...
I wish to deploy aC897VAW-E-K9with an addtional access point for our youth centre- what i want to do is give out a password to people to log on WWW - can the 897 be configured to do that?
Hello,
We have a VWIC3-2MFT-T1/E1 installed on a C2921-VSEC/K9. The E1 Card is intended for a
future PRI Voice Service.
We however recently recovered from a fiber cut on our primary link and have decided to use
an E1 Data Service for backup in case...
Hi ,I have 2 ADSL line with static IP from same ISP , when I active the 2nd dialer , I lose the access Internet or one dialer only can access to the internet , I think the 2 static IP 218.189.169.1xx and 218.189.169.2xx connected to the samegateway o...
hi,I have this quos setup in my router,class-map match-any mycomputermatch access-group name HOME_COMPUTERclass-map match-any mediamatch dscp efclass-map match-any signalingmatch dscp cs3match dscp af31!!policy-map queueclass signaling bandwidth ...
I have two ISP provide MPLS L2 VPLS , Is ISP redundancy possible with a VPLS ?I've already though about using IP SLA but there's issues when WAN in remote site is down I would have no way of knowing it.can someone explain how to acheive this ?
I've a problem in create subinterface Vlans a Cisco router. I want create subinterface vlans in a range ip (/24) with diffrent subnet mask.I want create subnet mask /29 prior /27 (no order).31.25.89.1/2931.25.89.9/2931.25.89.17/27then create number 3...
