Routing

I'm currently labbing a scenario in which I'd like to remove the Private-ASs that are within NLRIs that I'm sending to an EBGP neighbor. The issue is complicated by the fact that within the existing NLRIs, there is a single Public-ASN amongst the pri...

Hi,Lets say I'm configuring a regular router that stands between an internal network and the Internet, but I would like the internal network to have its own VRF (INSIDE) and to have the Internet its own VRF (OUTSIDE).Assuming that my WAN address is s...

                Hi,ISP has delivered the MPLS link on the MUX, Now we i am going to extented the cable from mux to cisco Router with the serial interface with RJ48 connector.Please let me know which cable should i use to extend the link Striaght or C...

Hi,I am trying to get DMVPN phase 2 working, I have recently decided to change all of our spoke routers default gateway to go over the DMVPN tunnel back to the hub. I have done this to reduce the admin work on firewall rules to the Internet and have ...

We have frame relay T1 circuit at one of our remote site. Which is connected to our core frame relay router which have DS3 circuit.Now we bought second T1 line at remote site and now I have to configure Bounded T1 with Cisco 1921 router.Can some one...

Hi everyone,I wanted to ask that when mtu is set to 1400 in GRE path then maximum data size packet allowed is 1376(1400-24).Shouldnt it be 1348(1440-24(gre)-20(IP)-8(icmp)).

Hum.... this is a headscracher...  I have the latest IOS for the 3560 switch.. I'd like to boot the switch and have it download the ios from my TFTP server during boot, thus running the updated IOS, instead of the IOS which is in FLASH.              ...

setup:Cisco 2651XMfrom ISP46.167.229.200/2846.167.229.201/2846.167.229.202/2846.167.229.203/2846.167.229.204/2846.167.229.205/28GW for all ips is 46.167.229.30on the router I have 3 VLANS192.168.40.0 --> fa0/1.40192.168.50.0 --> fa0/1.50192.168.80.0 ...

I have a ME-3400EG-12CS-M switch the ports 13 thru 16 have sfp's and are connection to other 3560 switches over fiber. The GIG  0/1 on the 3400 connects to the long haul sonet transport electrically. The IOS is Version 12.2(55)SE3. I can't ping or lo...

hi, would like to know implications/requisites on my setup.I have a working 3800 router which runs on bgp pretty well. Existing setup has 2 serial ports for the bgp and 1 gigabit port for the LAN.Now, i want to add another 3800 as a standby router ma...

Does anyone know why default temp tresholds on ASR1001 are set very low/high ?    At what temp level warnings will be sent out based on following sensors: Temp: Inlet      P1                Normal            32 Celsius Temp: Internal   P1            ...

Folks,I need your help regarding what would be the physical setup of the frame relay and BGP. I understand that the FR switch exists at the ISP site and HQ/Branches are connected to that switch whether fully meshed, partially meshed or whatever. Now ...