I am shaping my outbound router (2921) link to 50Mbs. I have my QOS policy nested inside my shaping policy and I have noticed (what I think) is a high amount of packet drops in one of my queues.Below is the output of 2 show policy-map interface g0/0...
Hi,I am having issues with global vrf route leaking.It is working in an evironnement that has a dialer interface or a static route, but if the isp at the customer location use a dhcp connection, I can't redistribute the global route into the vrf.Is t...
Hi everyone There is a backbone switch and 40 edge switch..I want create 5 users.But I dont want to create every swtich,I want to ceate a user and all edge switch can run this user,how can ı solve this problem?
Hi.I am installing a’ stack with 3st WS-2960S-48FPS with IOS c2960s-universalk9-tar.150-1.SE2bin.I am planning of using Auto-upgrade, and have installed flash:c2960s-universalk9-tar.150-1.SE2.tar on my master switch. But when reloading my stack who s...
hey, there,we have a device that is connected to a router 2800. from the router, I did a show cdp, it shows it is H.what exactly is this device? Please take a look at the attached file.thanks,Han
Hi,I was wondering how many ports this card has, I believe it is a single port, but I am a little bit confuse because in the overview of the cards says:http://www.cisco.com/en/US/prod/collateral/modules/ps5949/ps7175/product_data_sheet0900aecd80581fa...
Hi Friends, I need some help regarding VLANs. Here is my scenarion:A fiber connection from ISP is coming to a switch supplied by ISP, so only 1 port is active on it. That 1 port is connected to our firewall and then from firewall we have connections ...
hi, i have two different ISP in my cisco router 2811.local lan:10.10.40.0/24ISP1: x.x.x.xISP2:y.y.y.yi want half of the IP should be working with ISP1 and other half of the IP should be working with ISP2.If any one of the ISP link is down means all ...
Reviewing the PDF of both models, often find that the technical characteristics of the switches outperform small bussines ws-c2960 switches and much lower prices.Someone could clarify the difference lies in that technique and how we are cheaper if yo...
HelloThere are many CAt3560 with IOS 12.2(53)SE2 running in my client's network. Recently, those switches have been scanned by a tool "Netformx" and the report shows that IOS 12.2(53)SE2 is affected by advisory " Crafted ICMP Messages Can Cause De...
Hi,I am very new to high end cisco devices.(like 7600/6500 or ASR9K)Can someone please make me understand why do we login on RP. What actions we can perform after logging-on RP (route processor) or Why they are required ? Cant we make those by norma...
our WAN is connected via L2WAN and using EIGRP to connect the sites. Currently there are 35 EIGRP neighbors over L2WAN and we are to install 15 more sites and will be connected to the same L2WAN. Some sites are still using Cisco 2651XM and we would...
Hi Experts, I need your help. From my service provider i have IPV6 address for internet lease line.I want to configure this address in such a way that LAN user can access internet using ip v6. Its easy to configure same senario in IPV4...
Hellosuppose we have the following diagramusing RIPv2.RIPv2 will auto-summaries by default. i thought it will make summary to 192.168.1.0/25 since this includes 192.168.1.0/26 and 192.168.1.64/26. however i discoverd that it summaries to 192.168.1.0/...
Hi, I am looking at upgrading our 4503 to the 4507R+E. Just going through the configurations and a couple of commands seemed to have dropped off this release.1. I can no longer specify encapsulation type on a trunk. Does the 4507 auto sence encapsula...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 06-24-2025 07:06 PM | ||
| 06-24-2025 10:34 AM | ||
| 06-14-2025 01:24 AM | ||
| 05-15-2025 07:28 AM | ||
| 05-13-2025 03:49 AM |
| User | Count |
|---|---|
| 9 | |
| 7 | |
| 2 | |
| 2 | |
| 2 |
