Routing

Hello folks...I am new to using this forum so please bare with me...I only know a little about programming a CISCO router but I know the config I setup is not working...Here is what I want to do...The ISP provides us with IP Addresses via DHCP. Our p...

Hi,I have a few questions about PTP ( IEEE 1588/2008) behaviour:I want to separate PTP networks using VLANs, and use a transparent switch.The transparent switch sends packets over vlans? or it keeps them inside a vlan ? I mean if I make a few vlans d...

We have a remote 1760 with a T1 and DSL backup. It uses BGP for routing. It has route maps for the default route and backup path,router bgp 65000 no synchronization bgp log-neighbor-changes network 10.0.7.0 mask 255.255.255.0 neighbor 10.254.1.129 re...

I have configured two vrf LI and OAM  on a 7609 router. and inter vrf routing is enabled. I am able to see corresponding routes in either vrf.Basically two connected routes from OAM vrf are leaked into LI vrf and vice versa. The following output is s...

Hey all,First off, let me state that my technical knowledge is rather limited in regards to routing protocols and their limits/abilities.Some background:I work for a public safety project management office. A few months back we implemented a Fire Sta...

Good Morning,I have a 4500 Catalysts switched (4510 R ) that require the configuration to wiped back to factory default setting, How would i go about clearing the configuration on each module boardSorry if this question has been asked beforeThe chass...

Our company recently purchased a used Cisco 1811 router as a replacement for our Netgear fvg318.  I have been haunting both the Cisco support site and this site for the past two weeks, trying desperately to get the 1811 to act like a router, to no av...

Hi allI wanted to verify my understanding of QOS and make sure that I am on the right page with respect to it.Is it correct to say that QOS kicks in only when there is 100% utilization of bandwidth? If so, how does the router know about 100% utilizat...

I want to create a couple of non-routable VLANs that will be trunked across multiple switches. These VLANs will reside on the outside of my firewall. In fact they will connect my firewall(s) to their respective ISP device(s). Is this a typical config...

Hi,I have a pinging problem.  I have this cfg.Webservice PC --> 6506 switch ---> cisco1 3750 --> cisco2 3750 ---> PC1here the cfgs for each device and I removed some of the extra stuff.Cfg on cisco 6506 Sup720Router#sho runBuilding configuration...Cu...

HICan i upgrade the dram of a router say incase of 2800 ISR where can i get this info from as to what max capacity of dram are supported on a specific router.Regards in advance for Reply.

Hello everyone, I would like to push route for admin services (Vlan20) to bypass the firewall via an other connection (CSI to CSE). so my first choice was to create a route-map in (CSI) but I don't know how to do it. on my Firewall ASA, I don't have ...