Routing

Hi all,I would very appreciate if you can point me out to Cisco CLI command which begins OSPF Graceful Restart after all GR parameters are set.Is there "some" Graceful" reset/reboot?Thanks,Dmitry Petrunin

I am trying to upgrade CP Express to 2.5 and after the upgrade I bring up the webpage to login and I am prompted for my credentials, I enter them and I am authenticated.  However the CP Express home page never loads.  Has anyone ran nto this before a...

Hi all.I'd like to know what it is means regarding regex ' .* ' . To make sure, I wanna do cross-check.and If I know the specific AS number when I type down as show ip bgp. How can I find out the management ip address of that AS number?

hi need some help with static routes.i have 2 connections a single T1 for voip traffic only and a DSL line for data traffic.the dsl was migrated to a 2811 with out any issues now comes the time to move the T1 over.on the T1 side I am able to ping the...

Reason to do so is because the IP is running out, need to additional subnet.All the ISP is eBGP peering with each other in one VLAN, but due to growing number of ISPs the IP is running out and new subnet is added as secondary IP in VLAN.But the peeri...

Hello,I have an 1811 which is setup as an Internet router for about 20 users.  FastEthernet0 is connected to the ISP and is assigned a static IP.  I also assigned a static route to the ISP gateway.  I want the users to get an IP, subnet mask, gateway...

Hi,  I have 2 routers R1 with link to ISP1 and R2 with link to ISP2.  My R1 is acting as MC/BR1 and R2 as BR2.  I m monitoring 2 prefixes and master is learning the prefixes too.For one prefix,best is BR1 and for the other its BR2 depending on throug...

Can someone confirm the default login and password for the Integrated Services Engine Card Network Module? The documentation says the login is admin and the password is default but this isn't working and I've reset the card several times.http://www.c...

when i open external domain in my company can't work..but,i open external domain in my home it is work.please look at my diagram attach file.thank you.

I just got my first  3945 router and E3/T3 Network cards and when I do a sho ver I can see the E3/T3 card but when I do a show run all I see are the 3 GE interfaces.  How can I make this active?

I cannot find this info on the cisco site.

I am  running multicast on MPLS and the video content is getting freezed can any one let me knw the reasons.No ping drops observed on the Link , router supports multicast very well !!! Its a 2Mb Link on Radio frequency Awaiting for your responses pls