Routing

dear allcan anyone please guide me how can i control my bandwidth for each subnet which is behind the router. means i have got multiple client having their own subnets connected to a single router on FE0/1 and they are connected to wan via public IP ...

HiI have two T1s in a Multilink 1 groupand having issues with the bundle name not always being the same and thus causing only one T1 to be able to join the bundledebugging -------------------------1w5d: Se1/0:0 MLP: Link not added to bundle1w5d: Se1/...

pls answ to me, what ios for 827-4v from 12.4 can i use for IPSEC+ddns?i tested some from 12.4 but normaly working only 12.3(26)GD, but i want ddns feature? some from 12.4 is working with tracebacks, other is not loading - with error (loadprog: error...

Hi! I have 2 questions.Om my cisco 2811 (IOS 12.4(15) T9 IPBASE W/O Crypto) i am using 3 interfaces.And i have a pool of Global addresses: 200.x.z.97-200.x.z.126 255.255.255.0!-----------------------------!FastEthernet 0/1 description WAN interfaceip...

Hi guys. I'm getting ready to implement VOIP on our LAN. I will have a PRI gateway that takes calls out to the PSTN, so I do not need to worry about WAN issues. I am going to be using non-Cisco, SIP phones, and I will have two VLAN's setup - the n...

Dear Experts & friends,This is a HA related query and I am expecting you to share your experience here and help me. A same thread i started some months ago, but couldnt continue. I am starting it again. Mr.Jon Marshall helped me, but I missed to cont...

Hi,  I am trying to configure below commands in Cisco 4506 E with SUP 6 LE but these commands are not not supporting in the switch.Even QOS command is not taking in the siwtch....This was working fine in Cisco 4500 with SUP 2..not i upgared to 4506 E...

Hello,We have a project and details are in the following.Please also find my drawing in attachWe have two locations that connect each other with point to point metro ethernet.Metro ethernet switches is installed on each site by ISP. ISP allow to defi...

I am using a cisco 2811 router.It is not booting properly.It reboots continously by just decompressing the image repeatedly....Can someone help me in this issue....

Hi GuysI m looking exacly for cisco icon mentioned exactly in the attached file.I MEAN EXACLY THE SAME COLOR (THE OLD GREAN)Thanks

Hi All,We are currently doing a project to use pure IPv6 to access both IPv6 and IPv4 services such as IPv4 web-sitesCurrently,  the solution we found out is using IPv6 NAT-PT (or PAT) to translate IP  addresses between these two protocols and enable...

Hello, I am using a 1811W and CCP for configuration.  I am trying to assign client names to devices on the LAN so that when a network scanner is used, the  client name is displayed.  I have attached part of  the running config after a binding has bee...