Routing

Hi All, We have Four links running with BGP (Each of these links are running as Primary and also running as backup for other links). Recently we have owned TWO more links that will be configured under same BGP with same AS no. . These Two new Links w...

I'm currently using ipsec vpn to connect my host location to remote sites. I'd like to be able to use EIGRP which will require gre. What I'm after is some interface addressing clarification. I'll start with some detail on the current config. The IP's...

Hello folks,I have recently observed heavy CPU usage on one of our Cisco 1812W routers. I have been unable to find the cause of this, since the "sh proc cpu" does not show which process uses the CPU. The two command outputs below are taken at the sam...

Does anyone have any experience with the bandwidth points limits on the 7204?  The documentation says to limit to only 600 points per bus.  This really limits this router as far as fast ethernet interfaces is concerned.  Has anyone loaded theirs abov...

Hi AllI've configured a network with PE's and CE's what I have is EIGRP running between PE's and EBGP between PE and CE's. can't reach router loopback address of other CE's. Routing on the PE's works to all locations without a problem. I have DMVPN r...

Hello all,I am adding a 1941 router to our network to test a new comcast cable circuit with a /29 static block that they sold us. The only config I have done to the router is the interfaces and the default route. When I change my pc's default gateway...

I have a Cisco 2801 router that I'm trying to get the SDM to talk to. The message I get says that the router is an unsupported router.When I go to the SDM 2.5 q&a's it says that it'll talk to the 2801.Can anyone help?  It's probably something really ...

i'm trying to figure out how to do static nat for two ISPs when one of them gives us a static block and the other a dynamic ip.basically i've been made aware ofip nat inside source static x.x.x.x y.y.y.y route-map isp1ip nat inside source static x.x....

I have a WAN with an ISP Managed MPLS configuration on one side and a Customer configured gateway on the remote side.  I have been asked to add an additional MPLS circuit on the remote site and aggregate the two.  It appears as though multilink PPP i...

Hi,We  would get the functionality "Tcp windows Scaling" on a platform Catalyst 4500?Is it possible?ThanksByeDavid

I have two 3620 routers, both running IOS Version 12.3(22) and 3 2507  routers running IOS Version 12.1(20).  I am attempting to setup MPLS on  them and none of the commands show up in the routers at all. I realize that the 2500's may not be able to ...

I am having difficulty getting wireless clients to obtain an IP address from a Windows 2003 DHCP server.  The IOS bin was missing and I loaded the lasted IOS for this router.  Everything works except for wireless clients.  I have compared the old sta...