Hello guys I have a cisco 1721 router configured with a frame relay for a T1 service, the problem is sometimes de upload speed of my T1 drops to almost 10kb. and stays like that, the hwic serial interface gets hot. the ping for the router from th...
Hi,I've configured my Cisco 881G with a Vodafone 3G access, following the guide.It seems not to work , all the profiles are Inactive, especially the 2nd , which I configure.Here is my configuration and the show cellular output.An idea of what missing...
Greetings:We have a mixed BGP and OSPF routing environment. The routing protocol on the MPLS and point to point T-1s is mostly BGP with some OSPF (but moving to BGP). A vendor of ours to whom we have a WAN link advertises via OSPF (and can not advert...
Hi, I’m having some big issues with the config of a Async1 on a dialer in-band to a modem. We were using a 4000 to connect to the modem without any problem, but we just decided to change the 4000 to a 2801, all config from the 4000 were passed to th...
Hi,I have configured ip nat on Cisco 6153 switch and it is working fine. But I need to bypass the ip nat configuration for VPN users.eg: 192.168.1.1 is NATed to a global IP address, the ip nat working fine but the same server I need to connect for th...
Looking for a recommendation for a router purchase at a colo site where we'll be putting in a private line back to our main office. The colo hosts our web server, and so we will also be using IP transit services provided by the colo facility so the ...
Hi All,I have two routers R1 and R2 configured with multilink. Everything works fine when both the links are working fine but when one of the link becomes flapping link then ping response also suffers with many RTOs. Then i have to shut down the flap...
I have an odd situation and so far I can't find any answers or examples of how to do what I am trying to do. Our company has several branches that have two different circuits. The fist is an mpls circuit for our pip network, the second is typically...
Hello,I've inherited a project using the 1941 router and I'm having trouble figuring out a good way to setup the router to use dual-isp's. This will be for a residential system using residential isp's (cable modem and dsl modem).As far as I can tell...
hello,I have a 2811 router with 2 FastEthernet interfaces connected to two ISPs.FA0 / 1 is connected to ISP-1FA0 / 2 is connected to ISP-2,I created two access-list ACL1 (for isp1) and ACL2 (for isp2) for 2 to nat differents range of two network conn...
Hi,c2800nm-advipservicesk9-mz.124-18b.bin on a 2811 doesn't allow me to set Interface Null0 in a route-map to bin packets when PBR next hops are not avaliable. It says I have to use P2P interfaces for the "set interface".Does ayone know a workaround ...
