Routing

Apologies in advance if this question has been asked before.I have recently purchased a 877 router and have been delegated the task of configuing it for ADSL2 connectivity, the problem is router config side i havent a clue!! :) could anyone give me a...

I am trying to make logical Interfaces on my Cisco 2811 Ethernet WAN port, I will use two internet connections on this port,, both connections will be terminating on a layer 2 switch, D-Link, and the switch will be connected to the Router,Is it possi...

My company recently built a second building about 500 feet from our current facility and we had fiber optic cable run with media converters at each end to convert it back to CAT5e cable. We have a Linksys WRT54G in the first building which handles t...

Hello, I would like to make an high speed 2Gbps metro ethernet internet connection with ISP over 7600 or ASR router. What kind of connection should i use , 10Gbit interface or bundled of 1gbps interfaces with LACP ?What is your recommendations ? Kin...

Hi AgainI want to design /implement such the network mentioned in the attachment, who can help me in this project by providing me Powerful PDF and recommendation for successful implementation,also i have ibanking server plus SMS server so here Where ...

HelloI want to connect 3 offices in different country to H.Q in Saudi using IPSec VPN, can you post me PDF file includes such this scenario + the requirement to implement this project from A 2 ZKind regards

have three sites in mpls mesh. Head end has the fw/internet service, but I don't see how I am going to make this work short of creating a gre tunnel through the mpls. How else does the provider know how to forward and internet request

Hi, I have a few questions about design of a new metro e connection.We have one 3800 Router at the main office that will be recieving a 100 mb metro e connection.From the main office we will have 10 mb metro e connections to three other sites that ha...

Our router interface f0/0 is the local LAN. f1/0 is the MetroE link. Can untagged traffic on f0/0 be bridged to a subinterface on f1/0 and from there to a switch at another site? Goal is to move a server between sites without changing anything. I...

So i have a Cisco1841 router. Cisco suggested that i downgrade the IOS to (12.4.25bc1841-advipservicesk9-mz.124-25b.bin) in order to support IPSEC. Now i get an invalid input detected when i try to configure controller t1 0/0/0. Could this be an issu...

I know how hardloop workswhat is the purpose of softloop. how to set it up and what I should see on the outputThanks

Dear all,please take a look at the following output:**************************************router#show loggingSep 16 14:10:45: RT: SET_LAST_RDB for NET.NET.NET.NET/32 OLD rdb: via WAN1.WAN1.WAN1.WAN1 NEW rdb: via WAN2.WAN2.WAN2.WAN2Sep 16 14:10:45: ...

Hi,Area 0 is connectd to area 1 by two routers R1 and R2 area border routers. We need some routes to be sent to back bone area by router R1 and remaining all to be sent to backbone area by R2. so that when data from back bone , for some destination...

According to the output:c2800#show control-plane host open-portsActive internet connections (servers and established)Prot Local Address Foreign Address Service State tcp *:23 *:0 ...

Hello All,Can anyone explain meaning of the below error message:brse517(config-router-af)#redistribute static route-map SET-COMMUNITY-STATIC% "SET-COMMUNITY-STATIC" used as redistribute static into bgp route-map, set extcommunity rt not supported