Routing

HI,I have a 2501 router running with c2500-is-l_120-4.bin IOS.And i am running dhcp relay agent so that my local locations will get ip address from central DHCP server.Recently we have changed the DHCP server so it is required to change the helper-ad...

We have set up an MPLS with our telco. Main office is in Idaho, remote branch is in New Mexico. When we try to copy large files across the pipe, we get errors. If I've done an SSH session to the router in the remote office, I randomly lose my conn...

I am looking for a good book about disaster prevention and recovery.

Hello,We would like to set up a 200Mbps link between two remote sites of our company changes sites are equipped with router cisco 3845. FH link connecting the two sites proposed interfaces separate 100Mbps each. We explored the idea of making EtherCh...

HelloAny sample configuration to terminate site to site ,easy vpn tunnels using FQDN like vpn.cisco.com rather than ip address ?

I have configured two E1 in multilink. I am able to ping the multilink without any packet drops. However whenever my one of E1 goes down i get packet drops for next 30second until the traffic is shift to the other E1 which is up. Please advice what...

Is the Linksys 100 Base-FX Mini-GBIC SFP Transceiver supported on the Catalyst 2960 switch? I was told it was by the vendor and am having no luck getting it to work (no link). I have been able to get the MGBSX1 Gigabit Ethernet SX Mini-GBIC modules...

Iam having a 7606 router which is working in redunduncy SSO mode.the router standby SUP is rebooted by itself acouple of times.what might be the possible reasons???Many thanksMahesh K V

Can anyone please explain these commands to me? I am preparing for my BSCI exam and got stuck on this one learning BGP routing.. Here is the topology R1-R2-R3-R4(R2) to reach network 172.12.34.0 it needs to use next hope (R4) 10.1.1.4 (R2) to reach n...

HelloI have 2 separate links going to the same site. Each link has its own router from the local Telecom hanging off each circuit. Can I use a 2821 to load balance over these 2 links with the telecom routers attached?

I have an issue after attempting to use the same configuration to what is used in the following example.http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a0080950834.shtmlthe load balance seems to work fine.However i ...

Hi Team,I have a query if i have 2 routes to the same destination one is learned via ospf and another one is via static route with AD-110.Which route will be used for forwarding the data packet and why?

Hi, I just want to check if I have a connection like this R1 -- R2 and it is running eBGP between them. R1 has a route-map outbound to R2 that gives different MED values for a bunch of routes. I shutdown the link on R1 going to R2. The bgp tabl...